نتایج جستجو برای: heater probe treatment
تعداد نتایج: 1485168 فیلتر نتایج به سال:
[1] The heat pulse probe (HPP) technique has been successfully applied for estimating water flux density (WFD). Estimates of WFD have been limited to values greater than 10 cm d , except for two recent studies with lower detection limits of 2.4 and 5.6 cm d . Although satisfactory for saturated soils, it is recognized that current HPP capabilities are limited for applications in the vadose zone...
The thermal profiler is a scanning probe microscope with a miniature thermocouple (TC) at its tip which provides topographic and thermographic information by sensing heat conducted across a small air gap. The silicon micromachined thermal profilers (SMTP’s) described in this paper are structurally comprised of a probe that can be longitudinally actuated by an integrated electrostatically driven...
In dip-pen nanolithography ~DPN!, nanoscale chemical patterns are created by directly transferring chemical molecules from the tip of an atomic force microscope probe to a surface. We report the development of a thermally actuated probe array for DPN applications. The array consists of ten thermal bimorph actuated probes, each 300 mm long, with a lateral spacing of 100 mm. The probes are actuat...
Nanofluids are engineered fluids that contain a suspension of nanoparticles in a pure substance. Nanoparticles can be any variety of metals, metal oxides, or ceramics. They have been shown to increase heat transfer properties such as thermal conductivity, convective heat transfer, and critical heat flux(CHF). An optical probe used to detect phase was used to measure the void fraction during boi...
We report a wear-resistant ultrananocrystalline (UNCD) diamond tip integrated onto a heated atomic force microscope (AFM) cantilever and UNCD tips integrated into arrays of heated AFM cantilevers. The UNCD tips are batch-fabricated and have apex radii of approximately 10 nm and heights up to 7 μm. The solid-state heater can reach temperatures above 600 °C and is also a resistive temperature sen...
The microbunching instability driven by collective effects of the beam inside an accelerator can significantly degrade the final electron beam quality for free electron laser (FEL) radiation. In this Letter, we propose an inexpensive scheme to suppress such an instability in accelerators for next generation FEL light sources. Instead of using an expensive device such as a laser heater or RF def...
The high thermal conductivity of graphene and few-layer graphene undergoes severe degradations through contact with the substrate. Here we show experimentally that the thermal management of a micro heater is substantially improved by introducing alternative heat-escaping channels into a graphene-based film bonded to functionalized graphene oxide through amino-silane molecules. Using a resistanc...
This article describes tapping mode atomic force microscopy (AFM) using a heated AFM cantilever. The electrical and thermal responses of the cantilever were investigated while the cantilever oscillated in free space or was in intermittent contact with a surface. The cantilever oscillates at its mechanical resonant frequency, 70.36 kHz, which is much faster than its thermal time constant of 300 ...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید