This paper presents an experimental investigation of convective heat transfer coefficient for nanofluids using spiral pipe heat exchanger. The aim of this study is to investigate experimentally flow and convective heat transfer characteristics of water-based nanofluids flowing through a spiral pipe. The test section consist of spiral pipe with ratio pitch per diameter is 7.0 and mean hydraulic ...

In this paper, the heat pipe heat exchanger (HPHE) is considered and computational fluid dynamics (CFD) is used to analyze its evaporator’s performance and based on it, will be try to increase the thermal efficiency and to optimize the distribution of fluid flow in this type of heat exchangers. The CFD principles which are made use in this article are effective and appropriate methods that usin...

Heat pipes, as two-phase heat transfer devices with extremely high effective thermal conductivity. They can be cylindrical or planar in structure. Heat pipes can be embedded in a metal cooling plate, which is attached to the heat source, and can also be assembled with fin stack for fluid heat transfer. Due to the high heat transport capacity, heat exchangers with heat pipes have become much sma...

in this work, the characteristics of flow and heat transfer of a fluid containing nano particles of aluminum oxide with the water volume fraction (0.1-0.2-0.3)(v/v) percent of the reports. the overall heat transfer coefficient, heat transfer and the average heat transfer fluid containing nano water - aluminum oxide in a horizontal double pipe counter flow heat exchanger under turbulent flow con...

The ground thermal properties and the heat-transfer efficiency of the borehole heat exchanger (BHE) system are key parameters for designing ground-coupled systems. Proper design of such systems requires good knowledge of these parameters, providing an efficient and economic operation. For this purpose a test procedure known as Thermal Response Test (TRT) was developed in 1996 at the Oklahoma St...

abstract: in this study, al 2 o 3 /eg and tio 2 /eg nanofluids as coolants have been used in the double-tube heat exchanger. the hot solvent inlet heat exchanger must be cooled down with a specified amount. we can use nanofluids as coolants in the heat exchanger for optimization of the heat transfer area. therefore, the efficacy of nanofluids as coolants is verified. furthermore, flow rate of c...

Experimental investigations has been done to find out the heat transfer characteristics and friction factor of water based Al2O3 nanofluids as a coolant in  brazed plate heat exchanger. Plate heat exchanger either use horizontally or vertically. The base plate of the plate heat exchanger was kept inclined at (0⁰, 30⁰ ,60⁰, 90⁰). The experimentation have been done on the two different concentrat...

Research results have identified the use of heat pipe heat exchangers (HPHXs) for heat recovery as a way to reduce the pre-cooling and re-heating energy. This paper suggests decoupling dehumidification from cooling to reduce energy consumption. The feasible usage and the energy saving potential of heat pipe heat exchanger at the air handler dedicated in accomplishing this objective is investiga...