The curing reaction of a commercial cold-curing structural epoxy resin, specifically formulated for civil engineering applications, was analyzed by thermal analysis as a function of the curing time and the sample thickness. Original and remarkable results regarding the effects of curing time on the glass transition temperature and on the residual heat of reaction of the cold-cured epoxy were ob...

OBJECTIVE To investigate the effect of cavity preparation on the flexural strength of heat-curing denture resin when repaired with an auto-curing resin. MATERIAL AND METHODS Ninety-six rectangular specimens (64 x 10 x 2.5 mm) prepared from heat-curing denture base resin (Meliodent) were randomly divided into four groups before repair. One group was left intact as control. Each repair specimen...

UV cured epoxy systems represent complementary technology to the established heat cured epoxy systems for coating, adhesion and encapsulation of electronic devices. The UV cured epoxy systems offer significant benefits in terms of fast cure and thus very short production cycle time; low stress and better colour due to room temperature cure; process wise no mix ratio problem or anhydride handlin...

A micromechanics based thermal model was developed to predict the temperature and degree of cure (DOC) distribution inside a unidirectional fiber reinforced composite during the curing process. Using the concentric cylinder assemblage (CCA) model as a representation of the composite microstructure, the effective thermodynamic properties of the composite were computed based on the fiber and matr...

A prediction method for rubber curing process has historically received considerable attention in manufacturing process for rubber article with relatively large size. In recent years, there exists increasing demand for simulation driven design which will cut down the cost and time required for product development. In case of the rubber with relatively large dimensions, low thermal conductivity ...

The objective of this study is to use differential scanning calorimetry (DSC) to characterize the curing kinetics of Al2O3 and hydroxyapatite suspensions in acrylates. The heat evolution of the acrylate premix and ceramic suspensions in dynamic and isothermal curing was measured. The calculated activation energies for the acrylate premix and the two ceramic suspensions were 133, 74, and 78 kJ/m...

Modification of soy protein film properties by heat-curing was studied. Glycerin-plasticized films were cast from alkaline aqueous solutions of soy protein isolate. Films were heated at 80 or 95°C for 2, 6, 14, or 24 h. Tensile strength (TS), elongation at break (E), moisture content (MC), water solubility (WS), water vapor permeability (WVP), and color of heated and control films were measured...

Failure of the bond between acrylic teeth and the denture base resin interface is one of the major concern in prosthodontics. The new generation of denture bases that utilize alternate polymerization methods are being introduced in the market. The aim of the study is to evaluate the influence of polymerization methods on bonding quality between the denture base and artificial teeth. Sixty test ...

resin transfer molding (rtm) is a composite manufacturing process. a preformed fiber is placed in a closed mold and a viscous resin is injected into the mold. in this paper, a model is developed to predict the flow pattern, extent of reaction and temperature change during filling and curing in a thin rectangular mold. a numerical simulation is presented to predict the free surface and its inter...

introduction : this in vitro study was designed to measure and compare the amount of temperature rise in the pulp chamber of the teeth exposed to different light curing units (lcu), which are being used for curing composite restorations. methods: the study was performed in two settings; first, an in vitro and second was mimicking an in vivo situation. in the first setup of the study, three grou...