determination of the starter torque-speed diagram is a major task in the design or selection of a proper gas turbine starter. in this paper, the maximum power of the mgt-40 gas turbine starter was calculated based on the dynamics of the rotor, start-up logic, and compressor map. in a recent research, the pressure ratio was assumed as a linear function of the rotor speed and the required starter...

The exhaust gases of gas turbine power plant carry a significant amount of thermal energy that is usually expelled to the atmosphere this causes a reduction in net work and efficiency of gas turbine. On the other hand, the generated power and efficiency of gas turbine plants depend largely on the temperature of the inlet air, So that they both increase as the inlet air temperature decreases. Th...

Biomass is identified as one of the major renewable energy sources for electrical power generation. Heavy duty gas turbine engines are preferred for clean and efficient power generation. An extensive literature survey reveals that the governor droop setting of the heavy duty gas turbines varies from 2 percentage to 10 percentage. But it needs to be optimized for analyzing the dynamic response o...

an industrial gas turbine has the characteristic of decreasing output power on hot summer days while electricity demand peaks. steam injection in gas turbines has been used for many years to prevent the loss of performance of gas turbines caused by high ambient temperature. vodoley system is a closed steam injection gas turbine cycle (csigtc), which is known as a self-sufficient in steam produc...

Turbine blades of a gas turbine are responsible for extracting energy from the high temperature, high pressure gases. These blades are operated at elevated temperatures in aggressive environments and are subjected to large centrifugal forces. As many as 42 percent of the failures in gas turbine engines were only due to blading problems and the failures in these turbine blades can have dramatic ...

Turbine blade cooling is considered as the most effective way of maintaining high operating temperature making use of the available materials, and turbine systems with wet compression have a potential for future power generation because of high efficiency and high specific power with a relatively low cost. In this paper performance analysis of wet-compression gas turbine cycle with turbine blad...

In this paper a gas turbine power plant including air preheater (recuperator), heat recovery steam generator and air cooler system was modeled. Eight parameters were selected as the design variables.  Fast and elitist non-dominated sorting genetic algorithm (NSGA-II) was applied (to maximize the exergy efficiency and to minimize the total cost rate) for the mentioned cogeneration system. Th...

Power enhancement technologies for gas turbines such as inlet fogging, interstage water injection, saturation cooling, inlet chillers, and combustor injection are being used by end users without evaluating the potentially negative effects these devices may have on the operational integrity of the gas turbine. Specifically, the effect of these add-on devices, off-design operating conditions, non...

The cycles of the steam-injection gas-turbine systems are studied. The analyses of the parametric effects and the optimal operating conditions for the steam-injection gas-turbine (STIG) system and the regenerative steam-injection gas-turbine (RSTIG) system are investigated to ensure the maximum performance. Using the analytic model, the performance parameters of the system such as thermal effic...

R & D Journal of the South African Institution of Mechanical Engineering 2014, 30, 55-67 http://www.saimeche.org.za (open access) © SAIMechE All rights reserved. 55 A variety of working fluid thermodynamic property models are applied in gas turbine performance simulations, potentially giving rise to significant discrepancies in performance prediction. Literature indicates that little attention ...