Combustion in the cylinder of a spark ignition engine, particularly under low load conditions, is subject to cycleby-cycle variations due to factors such as mixture quality and quantity and internal exhaust gas recirculation. The major result of this phenomenon is an increase in the variability of indicated engine torque at a given engine operating point. Automotive control problems dealing wit...

Control of the inner engine torque of a combustion engine is very crucial for the overall performance of a dynamical combustion engine test bench. The main problem thereby is the usually unknown system behavior of the combustion engine, the time delay of the accelerator actuator which is used to control the combustion engine. In general the combustion engine is mounted on a combustion engine te...

Idle speed control in a fuel-injection engine system has focused on controlling long-term averages of engine speed, but short-term fluctuations of engine speed have been neglected. The torque differences among cylinders influence the idle stability and cause vibration of the vehicle. In this paper, we introduce two intelligent control systems to reduce the fluctuations of engine speed at idle, ...

The Center for Transportation Research (CTR) Vehicle Systems team modified a Nissan CK-2 Continuously Variable Transmission (CVT) for a diesel hybrid powertrain application. Mechanical and electrical modifications were made to the CVT, both internal and external to the transmission. The goal of this experiment was to investigate and demonstrate the potential of CVT for diesel engines hybrid ele...

Tradeo s between low feedgas emissions and smooth brake torque are discussed in the context of an engine equipped with variable camshaft timing VCT The use of VCT lowers the generation of feedgas emissions but adversely a ects the torque response However with the addition of an electronic throttle and knowledge of online torque the tradeo s between emissions and drivability in the VCT engine ca...

A torque control system is an important process in industries. The value of torque which is generated by DC servomotor depends upon a motor current. Since the torque control system uses the estimated current from an observer, it will receive an effect from torque disturbance (load torque) during an operation. The incorrect estimated current from the observer affects a current feedback signal. T...

In this paper an optimal method based on fuzzy logic for controlling parallel hybrid electric vehicles is presented. In parallel hybrid electric vehicles the required torque for deriving and operating the on-board accessories is generated by a combination of internal-combustion engine and an electric motor. The power sharing between the internal combustion engine and the electric motor is the k...

The wind speed has a huge impact on the dynamic response of wind turbine. Because of this, many control algorithms use a measure of the wind speed to increase performance, e.g. by gain scheduling and feed forward. Unfortunately, no accurate measurement of the effective wind speed is online available from direct measurements, which means that it must be estimated in order to make such control me...

Abstract: For disadvantages of the large flux and torque ripple and current waveform distortion of Direct Torque Control (BASIC-DTC), the DTC scheme for induction motor based on torque angle closed-loop control was presented and the proposed scheme was realized with three methods of torque angle closed-loop control. The main characteristics of three methods of torque angle closed-loop control f...