The development of chip morphology, critical cutting conditions of serrated chip formation and cutting forces were observed and measured by high speed machining experiment for 30CrNi3MoV hardened steel. Results show that the cutting speed and rake angle are leading factors to influence chip morphology and cutting forces. With the increase of cutting speed, the continuous band chip transforms in...

A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...

vibration cutting (vc), elliptical vibration cutting (evc) and ordinary cutting (oc) of in738 work-pieces have been experimentally investigated in the present research. the experiments were carried out by using single crystal diamond tool and ultra-precision cnc lathe. vibration frequency is 36.16khz and the amplitude is . the influence of various cutting parameters including cutting speed, fee...

* Corresponding author. E-mail address: [email protected] (T.E. Gr http://dx.doi.org/10.1016/j.biosystemseng.201 1537-5110/© 2015 IAgrE. Published by Elsevie Energycane is a promising bioenergy crop for warm south-eastern US regions and existing sugarcane machinery is being adapted for energycane cultivation. Because of energycane's comparatively higher fibre content and smaller stem diameters...

Chip formation during dry turning of Ti6Al4V alloy has been examined in association with dynamic cutting force measurements under different cutting speeds, feed rates and depths of cut. Both continuous and segmented chip formation processes were observed in one cut under conditions of low cutting speed and large feed rate. The slipping angle in the segmented chip was 551, which was higher than ...

A classical example of chatter prone machining is the boring operation. Turning under conditions with high vibrations in the cutting tool deteriorates the surface finish and may cause tool breakage. Severe noise is also a consequence of the high vibration levels in the boring bar. Active control is one possible solution to the noise and vibration problem in boring operations. In boring operatio...

Estimation and modeling of soft tissue deformation during cutting is important for developing a reality based haptic interaction model for surgical training and simulation. In this paper, we are interested in understanding the effect of parameter changes, such as the cutting speed and the angle of cutting, to develop a predictive model that is self consistent with the experimental observations....

Flexible blade cutting applied on thick layers of foam is very feasible for creating large sized physical models. The heated tool is set and moved in a circumferential tool motion along the front face of the layer. During these primary motions the cutting tool is positioned in order to ensure the best tool position and tool orientation for the cutting process. The adjustment of the tool positio...

PVC frame cutting process by guillotine is a common method that attracted attention of car parts and PVC decorating furniture producers. In this paper, the effects of main parameters such as cutting speed, lubricants and cutting frame holder pressure force on PVC frame section surface smoothness is investigated by experimental methods on a specified PVC frame sample and then by FEM simulation u...

0