During the milling process, one of the most important factors in reducing tool life expectancy and quality of workpiece is the chattering phenomenon due to self-excitation. The milling process is considered as a MIMO strongly coupled nonlinear plant with time delay terms in cutting forces. We stabilize the plant using two independent Emotional Learning-based Intelligent Controller (ELIC) in par...

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

The purpose of this article is to investigate the influences of carbon fibers on the fracture mechanism of carbon fibers both in macroscopic view and microscopic view by using single-point flying cutting method. Cutting tools with three different materials were used in this research, namely, PCD (polycrystalline diamond) tool, CVD (chemical vapor deposition) diamond thin film coated carbide too...

Introduction The formatIOn of periodIC patterns (stnatlOn) has drawn much attentIon In contInUOUS wave laser cutt time (s) tp time penod per oxidation cycle (s) U gas velOCIty profile (m/s) Uo streamwlse gas velOCIty (m/s) V Interfacial velOCIty (m/s) u lIqUId velOCIty In x dIrectIOn (m/s) v hqUId velOCIty In y dIrectIOn or cuttIng speed (m1s) v. fnctIon velOCIty (m/s) W actIvatIOn energy (J) W...

The anisotropy exhibited by single-crystal silicon in nanometric cutting is very significant. In order to profoundly understand the effect of crystal anisotropy on cutting behaviors, a large-scale molecular dynamics model was conducted to simulate the nanometric cutting of single-crystal silicon in the (100)[0-10], (100)[0-1-1], (110)[-110], (110)[00-1], (111)[-101], and (111)[-12-1] crystal di...

The purpose of this study was to obtain the trunk kinematics data during a change-of-direction task and to determine the relationship between trunk kinematics and the change-of-direction performance. The design of this investigation was a descriptive laboratory study. Twelve healthy male collegiate soccer players (age: 21.3 ± 1.0 yrs, body mass: 67. 7 ± 6.7 kg, and height: 1.75 ± 0.05 m) partic...

Repetitive arm movement and force exertion are common in meat cutting tasks and often lead to musculosketal disorders. In this study, the effects of the workbench height and the cutting direction on the levels of muscular activation of the upper extremity during meat cutting tasks were investigated. Seven subjects performed 4 trials of 20s each at the 4 different heights (0 cm, −10 cm, −20 cm a...

It is posted here for your personal use. No further distribution is permitted. Technique and knee loads in sidestep cutting 2 Abstract Purpose: To identify the effect of modifying sidestep cutting technique on knee loads and predict what impact such change would have on the risk of non-contact anterior cruciate ligament injury. Methods: A force platform and motion analysis system were used to r...