Most softening agents, such as rinse cycle fabric softeners, used by consumers at home contain cationic surfactants that have two long alkyl chains as their main component. The softening mechanism on fibers, especially cotton, has not yet been scientifically established, despite the market prevalence of fabric softeners for decades. One explanation for the softening effect is that the friction ...

In this paper, the ultraviolet protection factor (UPF) of plain knitted fabrics made from 20Ne cotton yarns, Coolmax yarn and their combinations in wet, relaxed and stretched states were studied. According to the fiber composition, fabric samples are divided into three groups including Group I (single cotton yarn), Group II (cotton/cotton combination) and Group III (Coolmax/cotton combination) ...

Yarn properties can be altered through blending fibres. According to the requirement different properties can be achieved by different blending ratios. Among the different blends cotton and polyester, cotton and wool, wool and acrylic, cotton and nylon, jute and acrylic, cotton and rayon etc are common. Flax and polyester has been a popular blend now-adays and depicts excellent properties than ...

The impact of card cylinder speed, card production rate and draw frame doubling on cotton yarn quality parameters was investigated by using the BoxBehnken experimental design. It was found that yarn tenacity, elongation and hairiness increase by increasing the number of draw frame doubling up to a certain level and then decrease by further increase in doubling. Yarn unevenness increased by incr...

The spinning limit for three different fibres (cotton, viscose rayon and polyester) on a Dref-3 friction spinning machine has been investigated. The change in yarn properties with progressive change in count has also been reported. The count range has been seen to be dependent on fibre type. As one progresses from very coarse to fine counts, the yarn tensile property remain fairly unaltered for...

This paper reports a comparative study between yarn mass and yarn diameter measurement systems using a differential capacitance tester and an optical coherent signal processing diameter tester respectively. A full description of the systems is presented along with their new contributions, namely 1mm length samples analysis for a capacitive tester and optical signal processing to eliminate the i...

yarn tenacity is one of the most important properties in yarn production. this paper addresses modeling of yarn tenacity as well as optimally determining the amounts of the effective inputs to produce yarn with desired tenacity. the artificial neural network is used as a suitable structure for tenacity modeling of cotton yarn with 30 ne. as the first step for modeling, the empirical data is col...

Yarn tenacity is one of the most important properties in yarn production. This paper addresses modeling of yarn tenacity as well as optimally determining the amounts of the effective inputs to produce yarn with desired tenacity. The artificial neural network is used as a suitable structure for tenacity modeling of cotton yarn with 30 Ne. As the first step for modeling, the empirical data is col...

Damage to cotton by micro-organisms causes a serious loss to the cotton farmer, manufacturer, and consumer. For this reason studies are in progress in the Department of Agriculture on the growth and effect of various micro-organisms which cause deterioration of cotton. In an earlier investigation in this laboratory by Rogers, Wheeler, and Humfeld (1940) the growth of Chaetomium globosum Kunze o...

The influence of different experimental conditions on the thermal comfort behavior of polyester-viscose and polyester-cotton ring and MJS yarn fabrics has been studied. The results show that the yarn structure and the fibre cross-sectional shape have a large influence on improving the thermal comfort of woven fabrics. The fabrics made from MJS yarns perform better than those of the ring yarn fa...