Current blast furnace technology is a two-stage ironmaking process that requires that iron ore concentrate first be formed into pellets, fired at 1260°C, cooled, transported to the blast furnace, and then re-heated to approximately 1500°C to produce pig iron. This heating, cooling, and then reheating wastes a great deal of energy, which would be saved if the ironmaking process had only a single...

Prevention and mitigation of acid rock drainage from mining are decisive for limiting environmental impact. Five by-products and industrial remnants (lime kiln dust, blast furnace slag, granulated blast furnace slag, cement kiln dust and fly ash) were investigated for their suitability to prevent acidity and metal(loid)s during leaching from highly sulfidic (50wt%, sulfide) waste rock in small ...

The high performance concrete is a highly complex material that consists of cement, water, blast furnace slag, super-plasticizer, coarse and fine aggregate. All of the materials play a certain role in the compressive strength of concrete. Combined with the information about age, the compressive strength of concrete is determined by eight attributes: 1. Cement (kg/m!) 2. Fly ash (kg/m!) 3. Blast...

This paper describes a review of the potential use of High Strength Incorporating Ground Granulated Blast Furnace Slag and Steel Fiber Reinforced Concrete used in construction industry to improve the structural strength and reduce steel reinforcements requirements. Blast furnace slag (GGBS) has been used as a supplementary material along with the cement. It helps in increasing the durability an...

smelting of hammerable iron and its treatment in antiquity and Medieval produced also by-product: slag. Because of small yields of iron the process produced only small amounts of slag that did not attract attention of smelters concerning its possible use. the use of slag pieces was only accidental. a lot of slag pieces and blocks from slag pit shaft furnaces were used as a material for mound bu...

in this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. for this reason, various experimental parameters such as ph, contact time and the primary ion concentration were investigated. the remaining concentrations of ions such as; mn2+ and fe2+ in water were measured by atomic adsorption spectroscopy. the chemical and phase composition of slag, ...

In recent years, the utilization of different non-traditional cements and composites has been increasing. Alkali-activated cementitious materials, especially those based on the alkali activation of blast furnace slag, have considerable potential for utilization in the building industry. However, alkali-slag cements exhibit very rapid setting times, which are too short in some circumstances, and...

The purpose of this study is to investigate porous vegetation concrete formed using the industrial by-products blast furnace slag powder and blast furnace slag aggregates. We investigated the void ratio, compressive strength, freeze–thaw resistance, plant growth and water purification properties using concretes containing these by-products, natural jute fiber and latex. The target performance w...

The present paper reports a statistical analysis of the performance of the blast furnace number X at the Bhilai Steel Plant over a period of sixteen years with the special reference to the quality and consumption of sinter . The variation in basicity and consumption of sinter, for the blast furnace data considered , is wide. The range of data covers high level to almost nil amount of raw limest...