This study evaluates the short-term resilient behaviour of cold in-place recycled (CIR) asphalt mixtures with bitumen emulsion when they are more similar to non-cohesive granular materials than conventional hot mixtures. Gyratory compacted CIR specimens were manufactured using different proportions bituminous and water, dynamic triaxial tests conducted at curing times. The moduli obtained exper...

Forms of selenium in bituminous coal, anthracite, and cokeite (natural coke) from Huaibei Coalfield, Anhui, China, have been determined by sequential solvent extraction. The selenium content in bulk samples is 4.0, 2.4, and 2.0 microg/g in bituminous coal, anthracite, and cokeite, respectively. The six forms of selenium determined by six-step solvent extraction are water-leachable, ion-exchange...

This paper presents results of investigation the possibility of replacing the mineral filler with fly ash from power plant “Gacko” in the bituminous aggregate mixture BNS 22A. The most important physical-mechanical properties of bituminous aggregate mixture with fly ash from power plant “Gacko” used as filler were investigated. Based on the results obtained it was concluded that fly ash from po...

Rutting is one of the most important distresses in asphalt pavements due to its frequency. Rutting or channeling, could be classified in three types: 1) mechanical deformation (rutting in subgrade or base), 2) plastic flow (unstable asphalt layer), and 3) wheel path consolidation. The plastic flow of bituminous mixture depends on many factors; one of this is the type of asphalt used in the mixt...

Bituminous mix design is a delicate balancing act between the proportions of aggregate sizes and bitumen content. For a given aggregate gradation, the optimum bitumen content is estimated by satisfying a number of mix design parameters recommended in the specifications. In this paper, some of new considerations related to the bituminous mix design are discussed. Bituminous mix design, with thes...

Abstract The increasing attention over cold recycling technologies as sustainable paving solutions requires a proper characterisation in terms of complex modulus for supporting the pavement design. Among recycled materials, cement bitumen treated materials (CBTM) benefit from presence both bituminous and cementitious binders. This research aims at characterising CBTM mixtures produced with thre...

Bituminous mix design is a delicate balancing act among the proportions of various aggregate sizes and bitumen content. For a given aggregate gradation, the optimum bitumen content is estimated by satisfying a number of mix design parameters. This article briefly discusses the current approaches in bituminous mix design and singles out the issues involved.

The development of transportation plays an important role in the development of nation. With flexible pavements being widely used in India, steps must be taken to increase the life of the bituminous pavements. Flexible pavements are often plagued with problems of cracking and rutting due to repeated traffic loads. Hence one needs to address these problems in order to improve the performance of ...

The Clean Air Act of 1990 initiated a tradable permit program for emissions of sulfur dioxide from coal-fired power plants. One effect of this policy was a large increase in the consumption of low-sulfur bituminous coal by coal-fired power plants. However, lowsulfur bituminous coal is also the ideal coking coal for steel production. The analysis presented here will attempt to determine how the ...

The facility is located four miles east of Hayden in Routt County, and consists of two BART-eligible boilers. Unit #1 is rated at 190 MW and is dry-bottom, wall-fired. Unit #2 is rated at 275 MW and is tangentially-fired. The Hayden boilers burn Colorado coal that primarily comes from two different mines in northwestern Colorado, the Twenty Mile Mine and the ColoWyo Mine. Coal characteristics a...