When an anisotropic material is subject to creep conditions and a complex state of stress, an anisotropic creep damage behavior is observed. Previous research has focused on the anisotropic creep damage behavior of isotropic materials but few constitutive models have been developed for anisotropic creeping solids. This paper describes the development of a new anisotropic tertiary creep damage c...

To maintain safety and reliability in power plants, creep-life prediction models have received much attention over the years. This article was designed to focus on conditions when a material structure is exposed extremely high temperatures pressures with help of finite element analysis. A direct comparison feasibility different models’ fitness suitability predicting creep damage presented this ...

Time-dependent creep stress redistribution analysis of thick-walled FGM spheres subjected to an internal pressure and a uniform temperature field is investigated. The material creep and mechanical properties through the radial graded direction are assumed to obey the simple power-law variation throughout the thickness. Total strains are assumed to be the sum of elastic, thermal and creep strain...

The creep behavior of bagasse-based composites with virgin and recycled polyvinyl chloride (B/PVC) and high density polyethylene (B/HDPE) as well as a commercial wood and HDPE composite decking material was investigated. The instantaneous deformation and creep rate of all composites at the same loading level increased at higher temperatures. At a constant load level, B/PVC composites had better...

A small punch test is one of the innovative methods that can be used to evaluate the properties of a material without destructive harm to the in-service component. Conventionally identifying material properties by a uniaxial test is widely applied to engineering. How the properties obtained from a small punch test can be applied with the same utility has been a goal. In 2006, European Code of P...

Time dependent plastic deformation in metals can occur at high temperatures. Typically the creep test is conducted to characterize the deformation features; however, the conventional uniaxial power-law creep test may be impractical for small scale materials. Accordingly, instrumented indentation techniques are frequently employed. This study concerns the employment of instrumented indentation t...

The creep behaviors of TA2 and R60702 at low and intermediate temperature were presented and discussed in this paper. Experimental results indicated that an apparent threshold stress exhibited in the creep deformation of R60702. Meanwhile, the primary creep phase was found as the main pattern in the room temperature creep behavior of TA2. Compared with exponential law, the power law has been pr...

The effect of grain size on the viscoplastic behaviour M5Framatome zirconium alloy thin sheets was investigated at high temperature under uniaxial tension, using a variety equiaxed microstructures with controlled sizes. In ? phase domain, Coble diffusional creep regime and dislocation were observed, in agreement literature. A negative sensitivity strain rate to highlighted upper part ?+? two-ph...

This study aims to identify the creep behavior of Zircaloy-4 fuel claddings under simulated reactivity initiated accident (RIA) thermo-mechanical conditions. In a previous work ballooning tests performed in RIA conditions were described. A challenge overcome when analyzing these experiments is that imply structural effects during deformation specimen have be taken into account material. this pa...

The compressive creep and recovery of foam earplugs was studied at various applied stresses leading to different fi nal creep strains. Deformation was determined from digital videos of the earplugs via image processing software. Creep could not be modeled by a single exponential in time; creep approximated a power law in time. Nonlinear viscoelasticity was observed: creep compliance depends on ...