In 4-stroke internal combustion engines, air-fuel ratio control is a challenging task due to the rapid changes of engine throttle, especially during transient operation. To improve the transient performance, managing the cycle-to-cycle transient behavior of the mass of the air, the fuel and the burnt gas is a key issue due to the imbalance of cyclic combustion process. This paper address the mo...

Respiratory Diseases are public health concern worldwide. The diseases have been associated with air pollution especially indoor air pollution from biomass fuel burning in developing countries. However, researches on pollution levels and on association of respiratory diseases with biomass fuel pollution are limited. A study was therefore undertaken to characterize the levels of pollutants in bi...

This paper describes active control of an aftertreatment system for a spark ignition engine equipped with a three-way catalyst and preand post-catalyst oxygen sensors. The control objective is to maximize the simultaneous conversion efficiencies of oxides of nitrogen and unburned hydrocarbons. Linear exhaust gas oxygen sensors are used to measure preand post-catalyst air-fuel ratio. A series co...

In the present study, the operating conditions of an anode-supported high temperature direct internal reforming (DIR) planar solid oxide fuel cell (SOFC) are numerically analyzed. SOFCs are the energy conversion devices that produce electricity and heat directly from a gaseous fuel by the electrochemical combination of that fuel with an oxidant. A planar SOFC consists of an interconnect structu...

Maximization of the catalyst efficiency in automotive fuel-injection engines requires the design of accurate control systems to keep the air-to-fuel ratio at the optimal stoichiometric value AF . Unfortunately, this task is complex since the air-to-fuel ratio is very sensitive to small perturbations of the engine parameters. Some mechanisms ruling the engine and the combustion process are in fa...

In this article the predictive control is suggested to control the injection fuel pulse width in such a manner that the air-fuel ratio deviates as little as possible from the stoichiometric ratio during the transients of the engine. The applied control strategy is based on the knowledge of an internal model of the airpath, predicting the change of the air flow through cylinders, and consequentl...

Air-fuel ratio control in gasoline engines has so far relied upon the fact that the stoichiometric air-fuel ratio of gasoline is an identified constant, largely thanks to its consistent chemical composition. In the case of Liquefied Petroleum Gas (LPG), chemical composition is subject to high variability due to geological and economic factors, amongst others. The implication of this variability...

Flexible fuel vehicles (FFVs) can operate on a blend of ethanol and gasoline in any volumetric concentration of up to 85% ethanol (93% in Brazil). Existing FFVs rely on ethanol sensor installed in the vehicle fueling system, or on the ethanoldependent air-to-fuel ratio (AFR) estimated via an exhaust gas oxygen (EGO) or λ sensor. The EGO-based ethanol detection is desirable from cost and mainten...