in this numerical study the the heat transfer and laminar nanofluid flow in the three-dimensional microchannels with triangular cross-section is simulated. for increase the heat transfer from the walls of the channel, semiattached & offset mid- truncated rib,s placed in the canal, and the tooth geometry and the impact is studied. in this study, the water is base fluid, and the influence of the ...

A mathematical model to describe the detailed three-dimensional transient heat transfer process in friction stir welding (FSW) is presented. This work is both theoretical and experimental. An explicit central diVerential scheme is used in solving the control equations, the heat transfer phenomena during the tool penetrating, the welding and the tool-removing periods that are studied dynamically...

introduction: frying phenomena occur during the immersion of the product in oil at a temperature of 150–200 ºc, where a simultaneous heat and mass transfer take place. this is the most popular thermal processes of potato cooking. this fast drying is critical to improve the mechanical and structural properties of the final product. these conditions lead to high heat transfer rates, rapid cooking...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

A new measurement technique for the determination of the heat transfer coefficient and the film cooling effectiveness is presented. It is based on a regression of multiple transient liquid crystals experiments using an electrical heater-foil producing a nonhomogeneous surface heat flux. This is particularly interesting for film-cooled surfaces where each cooling hole in the heater-foil leads to...

cooling towers are widely used in most industrial units to reject waste heat to the atmosphere. this paper deals with an experimental analysis of heat and mass transfer phenomena between water and air by direct contact in a cooling tower. the tower is filled with 6 type packing. in this study temperature and pressure drop and tower characteristics was used in determining experimentally the ther...

The transient preheating process of a regenerative oxidation bed placed in a coal mine methane thermal reverse-flow reactor is numerically investigated in this paper. The regenerative oxidation bed is heated by the burned gas which is generated from a burner and is distributed through manifolds, which is modeled in a three-dimensional, unsteady state and laminar flow system, and is assumed as a...