Two-phase heat transfer is experimentally examined through vertical small diameter tubes, D =1.45 and 2.8 mm using water under a pressure of 50 to 81 kPa and a natural circulation condition. The pool boiling correlation by Stephan-Abdelsalam and the thermosyphon boiling correlation by Imura, et al. predict the measured experimental data in the 2.8 mm tube with an error of -30%. A large heat tra...

natural convective heat transfer of nano-fluid in porous media is present in many advanced engineering applications. in this work, this problem has been computationally simulated, using lbm. the configuration used includes a cold exterior region and hot interior cylinders with one-, two-, or three-cylinder arrangements. however, the effective area for heat transfer has been kept the same for al...

Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...

Natural convection heat transfer was investigated experimentally in a concentric-cylinders annulus. To enhance the rate of heat transfer, pin fins were installed on the surface of the inner cylinder. Two fin arrangements were employed, namely, staggered and in-line arrangements. The length of the fins varied from 2 to 8 cm and the Rayleigh number Ra changed in the range from 5 x 105  to 5 x 106...

 Abstract: This paper presents the results of an experimental examination of the effect of non-uniform wall temperature on local heat transfer coefficient in a rotating smooth-walled square channel. Three different thermal boundary situations were investigated: (a) even and odd (four) wall uniform temperature, (b) even and odd (four) wall uniform heat flux, and (c) even (leading and trailing) w...

Fins are protrusions on a heat transfer surface to augment heat transfer rate from it. The increase in area exposed to convection in case of finned surfaces results in increased heat transfer rate. In this study heat transfer characteristics of a pin fin with perforation is numerically analyzed. A pin fin is fabricated and experiments are done under forced convection conditions. The experimenta...