Melanin, a kind of well-known multifunctional biomacromolecules that are widely distributed in natural sources. In this work, polyurethane (PU)/melanin nanocomposites with enhanced tensile strength and toughness were successfully fabricated via in situ polymerization. It was found that the tensile strength (σ), elongation-at-break (εmax), and toughness (W) were improved from 5.6 MPa, 770%, and ...

The influence of martensitic microstructure and prior austenite grain (PAG) size on the mechanical properties of novel maraging steel was studied. This was achieved by looking at two different martensitic structures with PAG sizes of approximately 40 µm and 80 µm, produced by hot rolling to different reductions. Two ageing heat-treatments were considered: both heat-treatments consisted of auste...

[1] This paper revisits the Arctic Ice Dynamics Joint Experiment (AIDJEX) assumptions about pack ice behavior with an eye to modeling sea ice dynamics. The AIDJEX assumptions were that (1) enough leads were present in a 100 km by 100 km region to make the ice isotropic on that scale; (2) the ice had no tensile strength; and (3) the ice behavior could be approximated by an isotropic yield surfac...

The influence of temperature on the strength properties of structural materials has not been studied in detail yet. In particular, there are the alloys whose dynamic elastic strength demonstrates anomalous growth with the increase of temperature. The spall strength usually shows little change with temperature, i.e. it decreases insignificantly up to 85% of the melting point, which is followed b...

A Fe-34.5 wt % Mn-0.04 wt % C ultra-high Mn steel with a fully recrystallised fine-grained structure was produced by cold rolling and subsequent annealing. The steel exhibited excellent cryogenic temperature properties with enhanced work hardening rate, high tensile strength, and high uniform elongation. In order to capture the unique mechanical behaviour, a constitutive model within finite str...

In this study, effect of transglutaminase (TGase) addition on physical, water barrier, optical and mechanical properties of mechanically deboned chicken meat protein (MDCM-P) films was investigated. When TGase was added to the films, the thickness increased, but the solubility decreased. Films treated with TGase exhibited higher water vapor permeability than control film (p<0.05). When TGase co...

Carbon fibres can be used as structural electrodes because they have a high tensile properties-to-weight ratio and a graphitic structure which enables lithium-ion intercalation. Carbon fibre specimens were used as electrodes in laboratory cells. It was found that the fibre undergoes an ultimate tensile strength drop and an axial expansion which depend on the measured capacity. The results sugge...

Recent experimental advances for the fabrication of various borophene sheets introduced new structures with a wide range of applications. Borophene is the boron atom analogue of graphene. Borophene exhibits various structural polymorphs all of which are metallic. In this work, we employed first-principles density functional theory calculations to investigate the mechanical properties of five di...

This work offers an analysis of the wire feedability-related properties of Al-5Mg solid wire electrodes bearing Zr. Effects of Zr content on microstructures and mechanical properties of the Al-5Mg alloys were studied. Experimental results have demonstrated that α-Al dendrites of the as-cast Al-5Mg alloy are refined, and the tensile strength, microhardness and roughness of the 1.2 mm wire electr...

The brittle behavior and low strength of CoSb3/TiCoSb interface are serious issues concerning the engineering applications of CoSb3 based or CoSb3/TiCoSb segmented thermoelectric devices. To illustrate the failure mechanism of the CoSb3/TiCoSb interface, we apply density functional theory to investigate the interfacial behavior and examine the response during tensile deformations. We find that ...