A self-developed rotary multi-cutter device cuts stainless steel wire ropes into segments to fabricate twisted wires. Stainless steel porous twisted wire materials (PTWMs) with a spatial composite intertexture structure are produced by the compaction and subsequent vacuum solid-phase sintering of twisted wires. The stainless steel PTWMs show two types of typical uniaxial tensile failure modes, ...

Damage and fracture mechanisms of two 2198 Al-Li thin sheet alloys having different thicknesses (2 and 6 mm) are investigated. Two heat treatments are studied: T3 and T8. Mechanical tests are carried out on flat specimens including smooth tensile samples and U-notched specimens (with various notch radii). Test data are used to identify the parameters of constitutive equations describing plastic...

High temperature tensile tests have been conducted on samples of a Fe-Ni based superalloy, Incoloy A-286, and significant ductility loss has been observed at 1220 °C. Titanium-rich, thin-film-like phase has been found on the inter-granular facets of fracture surfaces. It appears that sulfur content of Ti-rich phase was higher than that of the matrix. At 1220 °C, liquation of Ti-rich phases has ...

Fatigue is the progressive, localized, permanent structural change that occurs in materials subjected to fluctuating stresses and strains that may result in cracks or fracture after a sufficient number of fluctuations. Fatigue fractures are caused by the simultaneous action of cyclic stress, tensile stress and plastic strain. If any one of these three is not present, fatigue cracking will not i...

Effects of B and Cr additions on magnetostriction and the mechanical properties of polycrystalline Fe83Ga17 alloy were investigated. Small addition of B increased magnetostriction of Fe83Ga17 alloy slightly, and improved the room temperature ductility and tensile strength significantly. The elongation and tensile strength of the (Fe83Ga17)99B1 alloy increased to 3.56% and 548MPa compared with t...

Aalto University, P.O. Box 11000, FI-00076 Aalto www.aalto.fi Author Jouko Lehto Name of the doctoral dissertation Reinforcement ability of mechanical pulp fibres Publisher School of Chemical Technology Unit Department of Forest Products Technology Series Aalto University publication series DOCTORAL DISSERTATIONS 47/2011 Field of research Paper and Printing Research Manuscript submitted 2 Novem...

Magnesium alloys are primarily used in aeronautical and automobile industry in wide variety of structural characteristics because of their favourable combination of tensile strength (160 to 365 MPa), elastic modulus (45 GPa), and low density (1 740 kg/m), which is two-thirds that of aluminium). Magnesium alloys have high strength-to-weight ratio (tensile strength/density), comparable to those o...

In a tensile test of a bar or fiber formed from a transversely isotropic viscoelastic material, the initial motion in regions away from the clamps is a homogeneous uniaxial extension. If the applied tensile load is “tame” in the sense that it is given by a piecewise smooth function of time, then during the early stages of loading, the homogeneous extension of the specimen is also tame. It is, h...

In this study, polyamide-aluminum foil-polypropylene (PA-Al-PP) composite films with different orientation status of the PP layer were prepared, and their morphology, tensile, peeling and heat seal behavior were studied. The comparative study of tensile and fracture behaviors of single-layer film of PA, Al and PP, as well as the composite films of PA-Al, PP-Al and PA-Al-PP revealed that in PA-A...

The goal of the present research is to develop a better understanding of the tensile response of open-cellular aluminum 6061 T6 alloy. Both tensile and compression samples of this metallic foam were tested under constant strain rate conditions at 293, 423, and 523 K. Scanning electron microscopy was performed on individual struts to assess the modes and mechanisms associated with fracture. Theo...