In an effort to achieve high mechanical performance and improved dimensional stability, densification combined with oil-heat treatment (OHT) was performed. In our previous study, OHT was successfully applied to densified veneer, which resulted in improved dimensional stability. In the present study, the impact of OHT on densified wood veneer hygroscopicity and mechanical properties was determin...

The aim of this study was to investigate the effect of loading rate on the micro-mechanical properties of oak (Quercus petraea) wood. Bending strength, modulus of elasticity in bending, compression strength parallel to the grain and tensile strength parallel to the grain were determined using microsized test samples. Three different loading rates were used for each test. The first loading rates...

Dispersive soils which occur in many parts of the world are easily erodible and segregate in water pose serious problems of stability of earth and earth retaining structures. The mechanism of dispersivity of soils is reasonably well understood. However there is simple method to identify the dispersivity of the soils and even more difficult to quantify the dispersivity. Visual classification, At...

Gelatin films were prepared by casting. Tensile strength (TS) and elongation at break (Eb) of the gelatin films were found to be 46 MPa and 3.5%, respectively. Effect of gamma radiation (Co-60) on the thermo-mechanical properties of the gelatin films was studied. 2-hydroxyethyl methacrylate (HEMA) was added to the gelatin during casting varying (10% 30% by weight) and found to increase the TS s...

The decision whether to use peak or residual shear strengths for a stability analysis must be made in the context of a specific design situation. Yet even when the specific situation is defined, the decision of whether to use peak or residual shear strength is often unclear. In general, if there are potential construction, operation, or design conditions that might cause relative displacement b...

Rapid heat cycle molding (RHCM) is a special molding process capable of producing molded plastic parts with high surface quality and improved weldline strength and appearance. This study investigated the influence of the weldline on the tensile strength of RHCM and conventional injection molded (CIM) components. The test specimens with and without a weldline were cut from RHCM and CIM parts for...

An assignment of positive integer weights to the edges of a simple graph G is called irregular if the weighted degrees of the vertices are all different. The irregularity strength, s(G), is the maximal edge weight, minimized over all irregular assignments, and is set to infinity if no such assignment is possible. In this paper, we take an iterative approach to calculating the irregularity stren...

[1] The mechanical behavior of hydrate-bearing sediments subjected to large strains has relevance for the stability of the seafloor and submarine slopes, drilling and coring operations, and the analysis of certain small-strain properties of these sediments (for example, seismic velocities). This study reports on the results of comprehensive axial compression triaxial tests conducted at up to 1 ...

Modification of soy protein film properties by heat-curing was studied. Glycerin-plasticized films were cast from alkaline aqueous solutions of soy protein isolate. Films were heated at 80 or 95°C for 2, 6, 14, or 24 h. Tensile strength (TS), elongation at break (E), moisture content (MC), water solubility (WS), water vapor permeability (WVP), and color of heated and control films were measured...

The observation that “old” water dominates storm runoff suggests that release of low-solute water from soils rather than rainwater must cause storm runoff dilution. This inference is supported by sprinkling experiments in an 860-m catchment in the Oregon Coast Range, in which .200 mm of both high and low ionic strength precipitation produced similar concentration-discharge trends. Rainwater che...