A low transmission loss, simple mechanical structure, and broadband waveguide-to-microstrip line transducer has been developed with a polytetrafluoroethylene printed circuit board. This can fully cover the V-band, E-band, and W-band, and the transmission losses are typically 0.68 dB, 0.86 dB, and 0.78 dB, respectively, at the center frequency of each band. The transducer in the W-band was alrea...

This research aimed to redesign an appliance based on the biomechanical aspects in applied ergonomics. The product chosen for analysis was the household mixer, it is readily found in most homes of several families. The study enabled the identification of several potential risks and proposed biomechanical ergonomic solutions for each. Finally, it was possible to redesign the handle of the mixer,...

Most systems which require phase information use mixers somewhere in the measurement or comparison of the phase information. Theoretically, any mixer with a dc coupled port could be used as a phase detector. Practically, however, mixers often display some very non-ideal characteristics (e.g., dc offset) when used as phase detectors. The actual mixer chosen for a particular application will ofte...

An open structure SIS receiver, used already for astronomy at 345 GHz was tested at 470 and 690 GHz. Receiver noise temperatures considerably better than those of standard systems based on Schottky diode mixers were accomplished. A specific merrit of this system is the option to change the range of input frequencies by simply mounting a specific mixer element in a standard mixer block and by ex...

_I BHARMACIA GRADIENT MIXER GM-1 The prime requirement for the production of linear ionic strength gradients is efficient mixing of the components of the gradient. In the Pharmacia Gradient Mixer GM-1 this is achieved by a blade configuration which lifts the dense incoming solution from the bottom of the mixing chamber and distributes i t evenly throughout the whole eluant at a low stirring spe...

VOLUME 84, OCTOBER 2006 INTRODUCTION This work is motivated by a problem encountered in certain mixing processes that employ a centre line injector upstream of a static mixer. Static or motionless mixers have been adopted for a large number of blending and dispersion operations because they offer attractive features such as closed-loop operation, and no moving parts, in contrast to continuously...

In this thesis the linearity characteristics of passive mixers for wide band homodyne receivers are studied. The circuits are simulated using Cadence Spectre with models from a 65 nm RF/Analogue CMOS process. Linearity dependence of common mode voltage, load impedance, switch network arrangement and local oscillator drive circuitry is studied and analysed. The thesis also covers methods for the...

This article presents a direct down-conversion mixer for ultra-wideband systems on 0.18 m RF CMOS process. The proposed mixer uses a current bleeding technique and an internal resonant inductor to improve the conversion gain and noise figure of the conventional Gilbert-cell mixer. Effects of each technique are compared on mixer’s noise performance. Measured results show the conversion gain of 7...

This paper presents practical experiments on a harmonic rejection down-mixer, which offers up to 75 dB of harmonic rejection, without an RF filter. The down-mixer uses a two-stage approach; the first stage is an analog multi-path/multiphase harmonic rejection mixer followed by a second stage providing additional harmonic rejection based on blind adaptive interference canceling in the discrete-t...

res of SIS receivers now in the range 2-4 times the ), the overall sensitivity of radio astronomy sly degraded by atmospheric noise, and sometimes by cillator source. In spectral line measurements, wanted (image) sideband can be eliminated by using an o reduce local oscillator noise, balanced mixers can ealize image separating and balanced mixers using RF circuits, but they are difficult to fab...