In this study, two CCCT diagrams are drawn to be compared with a CCT diagram. The CCCT diagrams represent continuous cooling transformations in stress assisted state. The increased Md and Bd temperatures of CCCT diagrams were also compared with those of the CCT diagrams and the cause was investigated from both thermodynamic and metallurgical viewpoints. Thermodynamic examinations revealed that ...

Thermoelastic behavior of temperature-dependent (TD) and independent (TID) functionally graded variable thickness cantilever beam subjected to mechanical and thermal loadings is studied based on shear deformation theory using a semi-analytical method. Loading is composed of a transverse distributed force, a longitudinal distributed temperature field due to steady-state heat conduction from root...

The stability evaluation of the slope commonly uses limit equilibrium methods, for example, Fellenius’ method in Japan. The limit equilibrium methods have two limitations. (1) It is necessary to divide the sliding mass into slices, and to set up some additional equations to make the problem statically determinate. (2) It is necessary to search sliding surface with a minimum safety factor. Shear...

We investigate shear strength properties of wet granular materials in the pendular state (i.e., the state where the liquid phase is discontinuous) as a function of water content. Sand and glass beads were wetted and tested in a direct shear cell and under various confining pressures. In parallel, we carried out three-dimensional molecular dynamics simulations by using an explicit equation expre...

We study the transient drag force FD on a localized intruder in a granular medium composed of spherical glass particles. A flat plate is translated horizontally from rest through the granular medium to observe how FD varies as a function of the medium's initial volume fraction, ϕ. The force response of the granular material differs above and below the granular critical state, ϕc, the volume fra...

The objective of this study was to evaluate the tenderness of beef chuck and round muscles when enhanced with ammonium hydroxide and salt at different pump levels. A randomized, complete block design of 4 treatments and 3 muscles with 3 replications was used, with a total of 15 subprimals per treatment. Treatments included a 0% (CON), 15% (T15), 22.5% (T22), and 30% (T30) target pump. The trice...

Shear wave elasticity imaging (SWEI) is a new approach to imaging and characterizing tissue structures based on the use of shear acoustic waves remotely induced by the radiation force of a focused ultrasonic beam. SWEI provides the physician with a virtual "finger" to probe the elasticity of the internal regions of the body. In SWEI, compared to other approaches in elasticity imaging, the induc...

ao"length of opening dh, dl"distance from top of steel section to centroid of concrete force at high and low moment ends of the opening, respectively dr"distance from outside edge of flange to centroid of reinforcement *b"maximum bending deflection for unperforated beam *m,b"maximum bending deflection for a member with an opening Fy"yield stress of steel FM y"reduced axial strength of steel in ...

Elastography provides a powerful tool for histopathological identification and clinical diagnosis based on information from tissue stiffness. Benefiting from high resolution, three-dimensional (3D), and noninvasive optical coherence tomography (OCT), optical micro-elastography has the ability to determine elastic properties with a resolution of ~10 μm in a 3D specimen. The shear wave velocity m...

In this study, the cyclic behaviors of low rise concrete shear walls using recycled coarse or fine aggregates were investigated. Eight low rise Recycled Aggregates Concrete (RAC) shear wall specimens were designed and tested under a cyclic loading. The following parameters were varied: replacement percentages of recycled coarse or fine aggregates, reinforcement ratio, axial force ratio and X-sh...