In this study, the cyclic behaviors of low rise concrete shear walls using recycled coarse or fine aggregates were investigated. Eight low rise Recycled Aggregates Concrete (RAC) shear wall specimens were designed and tested under a cyclic loading. The following parameters were varied: replacement percentages of recycled coarse or fine aggregates, reinforcement ratio, axial force ratio and X-sh...

This paper summarizes a series of studies on the interface of fiber reinforced polymer laminates externally bonded to concrete substrates, carried out in the Laboratory of Engineering for Maintenance Systems, Hokkaido University. Appropriate test methods and bond models for shear bond, tensile bond and cleavage bond (bond under dowel force) are shown. Finally, experimental results on shear bond...

This paper presents a three-dimensional nonlinear degrading stiffness model capable of capturing stiffness degradation in bilateral directions for earthquake response analyses of reinforced concrete bridges. Stiffness degradations due to flexural and shear damage are considered. The model can trace the progress of damage from initial failure through gradual degradation of the member stiffness d...

Midto high-rise buildings are often braced by slender reinforced concrete (RC) walls, which are coupled by RC floor diaphragms. In design it is typically assumed that the walls act independently and the design base shear demand is computed neglecting any compatibility forces between the walls. Pushover analysis of systems comprising walls of different lengths have, however, shown that large com...

7 Corrosion of reinforcing steel in concrete can alter the interface between the steel and concrete and 8 thus affects the bond mechanism. This subsequently influences the behaviour of reinforced 9 concrete structures in terms of their safety and serviceability. The present paper attempts to 10 develop a numerical method that can simulate the behaviour of reinforced concrete walls subjected 11 ...

7 Corrosion of reinforcing steel in concrete can alter the interface between the steel and concrete and 8 thus affects the bond mechanism. This subsequently influences the behaviour of reinforced 9 concrete structures in terms of their safety and serviceability. The present paper attempts to 10 develop a numerical method that can simulate the behaviour of reinforced concrete walls subjected 11 ...

Abstract: Reinforced concrete shear walls have been used throughout the world as known resisting elements for the lateral wind and earthquake loads. They are mostly designed and constructed based on elastic calculations and therefore resulting in un-economical sections. In order to overcome this weakness, scientists have proposed different methodologies to account for the non linear behavior of...

This paper describes the design process of a 200 MHz Ground Penetrating Radar (GPR) and a battery powered concrete vertical concrete surface climbing mobile robot. The key design feature is a miniaturized 200 MHz dipole antenna using additional radiating arms and procedure records a reduction of 40% in length compared to a conventional antenna. The antenna set is mounted in front of the robot u...

coupled -shear walls are one of lateral load resisting systems in high and medium rise reinforced concrete buildings. the lateral structural response is exactly dependents on the shear walls behavior; therefore these elements must response well whenundergodifferent load conditions. the structures located in near-source region behave differently compared to those in near-source sites when subjec...