BACKGROUND Climate variability modifies both oceanic and terrestrial surface CO2 flux. Using observed/assimilated data sets, earlier studies have shown that tropical oceanic climate variability has strong impacts on the land surface temperature and soil moisture, and that there is a negative correlation between the oceanic and terrestrial CO2 fluxes. However, these data sets only cover less tha...

The surface heat flux response to underlying sea surface temperature (SST) anomalies (the surface heat flux feedback) is estimated using 42 yr (1956–97) of ship-derived monthly turbulent heat fluxes and 17 yr (1984–2000) of satellite-derived monthly radiative fluxes over the global oceans for individual seasons. Net surface heat flux feedback is generally negative (i.e., a damping of the underl...

The geothermal heat flux is a critical thermal boundary condition that influences the melting, flow, and mass balance of ice sheets, but measurements of this parameter are difficult to make in ice-covered regions. We report the first direct measurement of geothermal heat flux into the base of the West Antarctic Ice Sheet (WAIS), below Subglacial Lake Whillans, determined from the thermal gradie...

In this paper conjugated heat transfer in thermal entrance region through the sinusoidal wavy channel has been investigated. The fluid flow is assumed to be laminar, steady state, incompressible, and hydrodynamically fully developed. A constant heat flux is assumed to be applied on the outer edge of the channel wall. In this study the governing equations including continuity, momentum and energ...

Experimental studies and numerical simulation of growth and lift-off processes of single bubbles formed on designed nucleation sites have been conducted under low-gravity conditions. Merging of multiple bubbles and lift-off processes during boiling of water in the parabola flights of KC-135 aircraft were also experimentally studied. The heating area of the flat heater surface was discretized an...

An experimental study was carried out to investigate the effects of inlet pressure, sample thickness, initial sample temperature, and temperature sensor location on the surface heat flux, surface temperature, and surface ultrafast cooling rate using stainless steel samples of diameter 27 mm and thickness (mm) 8.5, 13, 17.5, and 22, respectively. Inlet pressure was varied from 0.2 MPa to 1.8 MPa...

Dissipation and flux-variance methods, derived from the turbulent kinetic energy and temperature variance budget equations in conjunction with Monin-Obukov similarity theory, were used to estimate surface fluxes of momentum and sensible heat. To examine the performance of these two methods, direct eddy correlation measurements were carried out above a nonuniform grass-covered forest clearing in...

This paper deals with the homogenization of a quasilinear elliptic problem having singular lower order term and posed in two-component domain an ε-periodic imperfect interface. We prescribe Dirichlet condition on exterior boundary, while we assume that continuous heat flux is proportional to jump solution interface via function ε γ . prove result for − 1 < by means periodic unfolding method ...

Pool boiling enhancement through surface modification has garnered the attention of many researchers for extending the limits of heat flux dissipation. Simulated copper chips were used in a pool boiling setup with water boiling at atmospheric pressure. Heat transfer performance of different microchanneled surfaces was compared to that of a plain surface. The results of the study showed that the...

We report a novel boiling heat transfer (NBHT) in reduced graphene oxide (RGO) suspended in water (RGO colloid) near critical heat flux (CHF), which is traditionally the dangerous limitation of nucleate boiling heat transfer because of heater failure. When the heat flux reaches the maximum value (CHF) in RGO colloid pool boiling, the wall temperature increases gradually and slowly with an almos...