it is expected that residential units may replace   traditional heat and power production systems with cogeneration ones. among the different cogeneration systems, fuel cell based systems are a suitable choice due to their high efficiency, high power density, low emission and low noise. in this paper, a cogeneration system based on solid oxide fuel cells is examined. the system, including the f...

In this paper, we propose an efficient approach to design optimization of analog circuits that is based on the reinforcement learning method. In this work, Multi-Objective Learning Automata (MOLA) is used to design a two-stage CMOS operational amplifier (op-amp) in 0.25μm technology. The aim is optimizing power consumption and area so as to achieve minimum Total Optimality Index (TOI), as a new...

microgrids are small-scale, low voltage (lv) power networks which employ renewable distribution energy resources (ders) with power electronic interfaces (peis). microgrids as single controlled units and active distribution networks require flexible control systems to ensure reliable and secure operation in different modes. these various operations of microgrid cause variations in voltage and fr...

In this paper, tuning of power system stabilizer (PSS) and thyristor controlled series capacitor (TCSC) is studied. The analysis of mode controllability is used to select the effective location for TCSC. The performances of TCSC equipped with a proportional-integral-derivative controller (P-I-D controller) and proportional-integral-derivative power system stabilizer (P-I-D PSS) are investigated...

This study proposes a combination of a fuzzy sliding mode controller (FSMC) with integral-proportion-Derivative switching surface based superconducting magnetic energy storage (SMES) and PID tuned by a multi-objective optimization algorithm to solve the load frequency control in power systems. The goal of design is to improve the dynamic response of power systems after load demand changes. In t...

Cold rolling process is a complicated process which can be optimized by changing in variables and settings. This paper presents a set-up optimization system developed to calculate reductions and inter-stand tensions for each stand of a five stand tandem cold mill. The main objective in this optimization is minimization of power consumption. First, by using the analytical method, the equations ...

Distribution of distributed generation resources in distribution systems has several advantages, including reducing losses, improving voltage profiles, reducing pollution, and increasing system reliability. However, one of the most important points regarding the placement of these resources in distribution networks is economic issues and the return on investment and the increase in profits from...

Introducing distributed generation into a power system can lead to numerous benefits including technical, economic, environmental, etc. To attain these benefits, distributed generators with proper rating should be installed at suitable locations. Given the similar effects of distributed generators and capacitor banks on operation indices of a distribution system, simultaneous assignment of best...

Conceptual design of a waste heat recovery cycle is carried out in attempt to enhance the thermal efficiency of a steam power plant. In the recovery system, super-critical an CO2 is employed as the working fluid operating in a Brayton cycle. Low grade heat rejected by the flue gases through the stack is used as the primary heat source, while a secondary heat exchanger utilizes th...