In this paper the possibility of using the pyrolysis oil derived from waste tyres as a collector in flotation of coal was evaluated. The pyrolysis oil was obtained at the initial and final pyrolysis temperatures of 400 and 700 C, respectively, and the heat holding time of 30 min. Flotation results indicated that the pyrolysis oil emulsion showed stronger collecting ability than diesel and the c...

The effect of impeller speed on the air flow in a selfaerated Denver laboratory flotation cell was investigated using computational modelling. Air is induced into the slurry by the impeller’s rotating action. The rate of air flow is determined by the suction pressure created by the impeller, the hydrostatic head of the slurry and the frictional losses along the delivery shaft from the inlet val...

Introduction: The presence of antibiotics due to toxicity and sustainability as well as organic compounds as a combination of hard biodegradable wastewater is an undesirable issue in many industries. The aim of this study was to evaluate the efficiency of dissolved air flotation process for aniline and penicillin G removal from aqueous solutions. Methods: This was an empirical-lab study to w...

In this study, the factors that influence the variability of soil to plant radionuclide transfer factors (TF) in tropical and subtropical environments were statistically analyzed. More than 2,700 TF values were obtained from the literature, and from this four broad soil groups and 13 plant groups were investigated. Additionally, different plant compartments were distinguished. The wide variabil...

A site-specific study is carried out to assess the suitability of froth flotation for desulphurization of reactive mine tailings at the Musselwhite Mine, Northern Ontario, Canada, to prevent acid mine drainage (AMD). The results from pilot scale flotation tests on an Outokumpu flotation unit are presented, which confirm that froth flotation is effective to reduce sulphide contents of tailings. ...

The type and dosage of flocculants used in the middle thickener copper-molybdenum plant, addition to adjusting quality recycled process water, is very effective on floatability molybdenite. In this study, effect starch-based flocculant (wheat starch) was investigated efficiency molybdenite flotation, molybdenum processing plant. First, sampling from overflow underflow Mo circuit (in industrial ...

Solid/liquid separations are a mature technology area and few new developments occurred in seventies and eighties. However, last decade witnessed appearance of a significant number of new innovative systems in this field. (Rubio et al., 2002) This paper describes new developments in mixing, coagulation, flocculation and flotation systems for industrial wastewater treatment. (Ross et al., 2000; ...

INTRODUCTION The diagnosis of intestinal parasitic infections depends on the parasite load, the specific gravity density of the parasite eggs, oocysts or cysts, and the density and viscosity of flotation or sedimentation medium where faeces are processed. OBJECTIVE To evaluate the concordance between zinc sulphate flotation and centrifugal sedimentation in the recovery of parasites in faecal ...

Froth flotation is the most widely used method of separating minerals from one another. The basis of this process is to control the hydrophobicity of the minerals to be separated. The most commonly used measure of hydrophobicity is the water contact angle (θ), which is usually measured on polished mineral surfaces using either sessile drop or captive bubble technique. However, contact angle is ...

The purpose of this study was to evaluate the influence of variables in a flotation technique for the recovery of Toxocara canis eggs from soil. The trials were done under standardized conditions on one gram of previously sterilized soil samples contaminated with 200 eggs of T. canis. The following variables were evaluated in serial steps: sieving; type of wash; time of stirring; resuspension o...