In this paper, a novel approach is proposed for selective compensation of main voltage harmonics in a grid-connected microgrid. The aim of compensation is to provide a high voltage quality at the point of common coupling (PCC). PCC voltage quality is of great importance due to sensitive loads that may be connected. It is assumed that the voltage harmonics are originated from distortion in grid ...

–With the widespread use of harmonic generating devices, the control of harmonic currents to maintain a high level of power quality is becoming increasingly important. An effective way for harmonic suppression is the harmonic compensation by using active power filter. This paper presents a comprehensive survey of DSTATCOM control strategies put forward recently. It is aimed at providing a broad...

Harmonic problems are increasing on MV systems, especially with the application of power factor correction capacitors or extensive underground networks that resulting resonances close to the fifth harmonic. This paper describes two case studies of solving harmonic resonance problems on distribution systems with the design of harmonic filters that provide both power factor correction and harmoni...

This paper describes a switched audio amplifier that achieves high efficiency without the major drawbacks associated with this kind of amplifiers. The problems of high harmonic distortion and low rejection of supply variations are minimised by use of One Cycle Control. A new filter topology allows load impedance variation without gain variation in the audio band.

Second-harmonic control is implemented in a balanced common-emitter configuration to facilitate frequency-independent third-order intermodulation distortion cancellation. Moreover, this circuit configuration facilitates a simultaneous match for either power and linearity or noise and linearity. Experiments demonstrated an improvement of over 15 dB in the output third-order intercept point while...

Nonlinear loads generate harmonic currents and voltages in power systems. This paper investigates the effect of inverter output multiple-filter with nonlinear loads on the inverter input current and load voltage. To verify the proposed filter, various simulation results using Matlab/Simulink are presented under nonlinear loads.

• The circuit used for the phase angle control in triac-based single-phase ac regulators (ac to ac voltage converters) • The operation of the various blocks used in the circuit, along with the waveforms • The harmonic analysis of the output voltage of a single-phase ac regulator with resistive load

In this paper, by using the data of steel melting plant which contains major non-linear load i.e., induction furnace, we modeled such a system, which contains three 12-tons induction furnace in PSCAD software and simulated for three different operating conditions & studied harmonic pattern. Keywords—Induction Melting Furnace;Steel Melting Shop;Harmonics Analysis;Power Quality.

In this paper, an approach is proposed for accurate locating of single phase faults in transmission lines using voltage signals measured at one-end. In this method, harmonic components of the voltage signals are extracted through Discrete Fourier Transform (DFT) and are normalized by a transformation. The proposed fault locator, which is designed based on Random Forests (RF) algorithm, is train...

A new approach to short-term electrical load forecasting is investigated in this paper. As electrical load data are highly non-linear in nature, in the proposed approach, we first separate out the linear and the non-linear parts, and then forecast using the non-linear part only. Semi-parametric spectral estimation method is used to decompose a load data signal into a harmonic linear signal mode...