The efficient depolymerization and hydrodeoxygenation of enzymatic hydrolysis lignin are achieved in cyclohexane solvents over a gamma-alumina supported nickel molybdenum alloy catalyst single step. Under initial 3 MPa hydrogen at 320 °C, the highest overall cycloalkane yield 104.4 mg/g with 44.4 wt% selectivity ethyl-cyclohexane was obtained. reaction atmosphere temperature have significant ef...

Oxide-supported amine materials are widely known to be effective CO2 sorbents under simulated flue-gas and direct-air-capture conditions. Most work has focused on amine species loaded onto porous silica supports, though potential stability advantages may be offered through the use of porous alumina supports. Unlike silica materials, which are comparably inert, porous alumina materials can be tu...

We previously reported the five-to-six-year results of the use of third-generation alumina-on-alumina bearings in a consecutive series of 100 primary cementless total hip arthroplasties. This report presents the longer-term outcomes of these same bearings, at a minimum of ten years postoperatively. Eighty-six of eighty-eight hips available for the study retained the original bearings at the tim...

In an Al2O3-TiO2 mixed oxide system, the incorporation of TiO2 to alumina is known to increase the acidity of the resulting mixed oxide; depending strongly on the preparation method and the titania concentration. When using TiO2 as a support of NiMo catalysts, initial catalytic activity in hydrodesulfurization reactions is much higher than that on catalysts based on pure alumina. One of the mai...

This second paper in a series describes the relationship between grain growth kinetics and grain boundary complexions in silicadoped alumina. Dense high-purity silica-doped alumina samples were annealed for various times in the temperature range of 13001 and 19001C and their grain growth behavior was quantified. Four different grain boundary complexions were observed in silica-doped alumina, al...

In this paper, the influence of the atomic layer deposited alumina (Al2O3) thin films on the dynamics of a high-Q mechanical silicon oscillator was experimentally studied. The resonance frequency and Q value of uncoated oscillators used in this work were about f0 = 27 kHz and Q = 100 000 at p < 10−2 mbar and T = 300 K. Deposited alumina film thicknesses varied from 5 to 662 nm. It is demonstrat...

A zeolite NaA (A-type zeolite of ca. 0.4 nm pore size; Linde Type A, LTA) membrane for the dehydration of alcohol was characterized by X-ray diffraction analysis (XRD). Also, the relationship between the X-ray absorption and the EtOH/H2O pervaporation (PV) dehydration performance (water selectivity and permeation flux) of the LTA membrane was first investigated. The LTA membranes used here were...

The concentration of alumina in the electrolyte is of great significance during the production of aluminum. The amount of the alumina concentration may lead to unbalanced material distribution and low production efficiency and affect the stability of the aluminum reduction cell and current efficiency. The existing methods cannot meet the needs for online measurement because industrial aluminum ...