Operation Theatre (OT) is the most important area where precise controlled on indoor air quality is required because it is directly related to patient health and its recovery period. This work aims to study and visualize the airflow distribution of conventional flat air diffuser ventilation system and newly designed angular air ventilation system in OT. Angular Air Distribution (AAD) system is ...

Neutral boundary layer (NBL) flow fields, commonly used in turbine load studies and design, are generated using spectral procedures in stochastic simulation. For large utility-scale turbines, stable boundary layer (SBL) flow fields are of great interest because they are often accompanied by enhanced wind shear, wind veer, and even low-level jets (LLJs). The generation of SBL flow fields, in con...

Measurements were made of the flow field structure and the near field parameters of a jet exhausting from a sonic nozzle with a 1.27 cm exit diameter. Compressed air was used for obtaining stagnation pressures up to ~ 5 atmospheres. The jet exhausted vertically from a settling chamber into an acoustically insulated room and through an insulated duct out through the roof. Measurements were made ...

Digital signal processing (DSP) occurs in communications, audio, multimedia devices, imaging and medical equipment, smart antennas, automotive electronics, MP3 players, radar and sonar, and barcode readers. This algorithm can be implemented in Microsemi® system-on-chip (SoC) Products Group flash based field programmable gate array (FPGA), mixed signals FPGA, and also radiation-tolerant FPGA. Th...

www.xilinx.com 1 © Copyright 2012–2013 Xilinx, Inc. Xilinx, the Xilinx logo, Artix, ISE, Kintex, Spartan, Virtex, Vivado, Zynq, and other designated brands included herein are trademarks of Xilinx in the United States and other countries. All other trademarks are the property of their respective owners. The ability to control system failure modes through fault-tolerant design requires an implem...

Despite recent research efforts improving Additive Manufacturing (AM) systems, quality and reliability of AM built products remains as a challenge. There is a critical need to achieve process parameters optimizing multiple mechanical properties or geometry accuracy measures simultaneously. The challenge is that the optimal value of various objectives may not be achieved concurrently. Most of th...

personal samplers or in general blunt body samplers are widely used in occupational hygiene for collecting air contaminants in the work environments. this work is part of an ongoing research into the performance evaluation of personal samplers, particularly in terms of their aerodynamic properties. velocity profiles have been measured around and within typical cylindrical sampling devices, plac...

this study presents a computational study of mixture formation, flame front movement, combustion process and emission formation at the various spray angles and number holes in a direct injection diesel engine. this work is carried out in a direct injection om355 diesel engine at four and five holes with 130
, 135
and 140
spray angles. the amount of fuel injected per cycle is constant at all s...

the effect of partial slip and temperature dependent fluid properties on the mhd mixed convection flow from a heated, non-linearly stretching surface in the presence of radiation and non-uniform internal heat generation/absorption is investigated. the velocity of the stretching surface was assumed to vary according to power-law form. thermal transport is analyzed for two types of non-isothermal...