behaviors of stress corrosion cracking (scc)in martensitic stainless steel(aisi 420) and low carbon austenitic stainless steel (aisi 316l) have been compared under different conditions of temperature, environment (mgcl2), and strain rate. the results show that decreasing strain rate has detrimental effect on mechanical properties of both steels, including their strength and ductility. fractogra...

Aliphatic amines, such as n-hexylamine (primary), di-n-hexylamine (secondary) and tri-n-hexylamine (tertiary amine), react with tetrabromophenolphthalein ethyl ester molecules (TBPEH) to form reddish or red-violet charge-transfer complexes (CT complexes) in 1,2-dichloroethane (DCE). The absorption maxima of the CT complexes with all primary amines occur at around 560 nm, with secondary amines a...

Thin AISI 430 ferritic stainless steel sheets containing 18% Cr were hardened by continuous-wave laser beams under different conditions. A symmetric double treatment platform was developed to operate two lasers simultaneously in order achieve a homogenous microstructure through the specimen and avoid overheating associated with single treatments on one surface. The influence of linear energy de...

..................................................................................................................................................... vii

Addition of titanium (Ti) to ASTM A710 Grade B Cu-precipitation-strengthened steel significantly increases the impact absorbed fracture energy and reduces the ductile-to-brittle transition temperature. The effect of Ti correlates with the reduction of the amount of pearlite in the ferritic microstructure. A thorough study of the mechanical properties of Ti-modified A 710-B steel is presented.

Four mechanical surface treatments have been considered for the application to austenitic stainless steel structures. Shot peening (SP), laser shock peening (LSP), ultrasonic impact treatment (UIT) and water jet cavitation peening (WJCP), also known as cavitation shotless peening (CSP), have been applied to 8 mm thick Type 304 austenitic stainless steel coupons. This study considers the merits ...

Direct metal SLS processes use a high power laser beam to selectively fuse fully metallic powder to directly produce functional metal components or tooling. As a thermal dynamic process, it inevitably causes thermal stresses, stress-induced deformations and cracking. Understanding these is very important in controlling residual stresses and stress-induced deformations. In this research, the res...

This study focuses on the semiconductor properties of passive films formed on AISI 420 stainless steel immersed in four nitric acid solutions under open circuit potential (OCP) conditions. For this purpose, the passivation parameters and semiconductor properties of passive films were derived from potentiodynamic polarization and Mott–Schottky analysis, respectively. The OCP plots showed that th...

An investigation of the effects of fatigue on A533B steel under constant load amplitude is reported in this paper. It was found that the plastic strain of the sample accumulated logarithmically with the number of stress cycles after initial fatigue softening. Based on the fact that plastic strain is often linearly related to the coercivity of material, at least for small changes of H c , a phen...