The paper extends a mean value model of a parallel turbocharged internal combustion engine with a crank angle resolved cylinder model. The result is a 0D engine model that includes the pulsating flow from the intake and exhaust valves. The model captures variations in turbo speed and pressure, and therefore variations in the compressor operating point, during an engine cycle. The model is used ...

The overall heat transfer process within the in-cylinder for port injection hydrogen fueled internal combustion engine (H2ICE) has been investigated through simulation, while the experimental data has been utilized for validation purpose of the adopted numerical model. One-dimensional gas dynamics was used to describe the flow and heat transfer in the components of the engine model. The engine ...

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) x 10(8) cm(-3). The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world dri...

Premature combustion that affects outputs, thermal efficiencies and lifetimes of internal combustion engine is called “knock effect”. However knock signal detection based on acoustic sensor is a challenging task due to existing of noise in the same frequency spectrum. Experimental results revealed that vibration signals, generated from knock, has certain frequencies related to vibration resonan...

Engine testing involves measurement of rotating speed and torque of the engine by applying load controlled by a dynamometer connected to its output shaft. HORIBA has developed various types of dynamometer for the purpose of engine testing. They are mainly classifi ed into two types; one is absorbing only dynamometer such as hydraulic dynamometers and eddy-current dynamometers, the other is abso...

The paper presents a type of observer based on reduced to minimum set of engine parameters measured directly: turbine-compressor rotational speed, engine inlet air pressure and temperature and atmospheric pressure. Results of application in analysis of data recorded during engine operation in non-stationary states of SO-3 engine (powering TS-11 Iskra aircraft) are presented. Possibilities of th...

A parametric method based on spatial filter techniques (beamforming) is proposed to estimate the propagation speed of acoustic waves. The propagation speed estimate is analyzed for the case of narrowband signals and compared to the maximum likelihood estimate (MLE) of the propagation speed. It is shown that for an array of 3 sensors our estimate coincides with the ML estimate but its performanc...

We demonstrate a novel approach to modulating the motion speed of catalytic microtubular engines via laser irradiation/heating with regard to small-scale heat detection. Laser irradiation on the engines leads to a thermal heating effect and thus enhances the engine speed. During a laser on/off period, the motion behaviour of a microengine can be repeatable and reversible, demonstrating a regula...

Automotive emission is becoming a critical threat to today’s human health. Many researchers are studying engine designs leading to less fuel consumption. Gearbox selection plays a key role in an engine design. In this study, Taguchi quality engineering method is employed, and optimum gear ratios in a five speed gear box is obtained. A table of various gear ratios is suggested by design o...