A detailed approach to evaluate the sub-surface damage of diamond wire-sawn monocrystalline silicon wafers relating to the sawing process is presented. Residual stresses, the presence of amorphous silicon and microcracks are considered and related to diamond wire velocity and cutting ability. In particular, the degree of amorphization of the wafer surface is analyzed, as it may affect the etchi...

In this article, the studies undertaken on brazed diamond tools were reviewed. The influences of brazing alloys with different active elements quality are emphatically discussed. differences in micromorphology, friction and wear properties, mechanical properties diamonds caused by three described detail. evaluation is discussed from several aspects, such as difference microstructure diamond/bra...

After viewing a colored figure on a uniform gray background, an observer will see a negative afterimage after the colored figure disappears. This study shows that the shapes of afterimages vary systematically according to the shape of the adaptation stimuli, a phenomenon that could be caused only by cortical shape adaptation. In the experiments reported here, participants typically saw a hexago...

The use of an artificial joint is always related to a certain amount of wear. Its biological effects, e.g., the osteolysis potential, are a function of the bulk material as well as its debris. Following comprehensive experiences with polyethylene (PE) wear, material science is tracking two ways to minimize the risk of a particle-induced aseptic implant loosening: (i) reduction of the PE debris ...

Amplitude modulation atomic force microscopy (AM-AFM) is one of the most popular AFM modes because of the reduced tip-sample interaction, compared to contact mode AFM, and the ability to acquire high-resolution images while interrogating the sample's material composition through phase imaging. Despite the reduced tip-sample interaction, tip and sample wear can occur through gradual atomic scale...

Coand Fe-based alloys produced by powder technology are being widely used as a matrix for diamond-containing composites in cutting, drilling, grinding pplications, etc. The severe service conditions demand that the mechanical and tribological properties of these alloys be improved. Development of metal-matrix composites (MMCs) and alloys reinforced with nanoparticles is a promising way to resol...

Cubic silicon carbide (SiC) is an extremely hard and brittle material having unique blend of material properties which makes it suitable candidate for microelectromechanical systems and nanoelectromechanical systems applications. Although, SiC can be machined in ductile regime at nanoscale through single-point diamond turning process, the root cause of the ductile response of SiC has not been u...

Consolidated bodies of polycrystalline diamond with grain sizes less than 100 nm, nano-polycrystalline diamond (NPD), has been experimentally produced by direct conversion of graphite at high pressure and high temperature. NPD has superior hardness, toughness and wear resistance to single-crystalline diamonds because of its peculiar nano-textures, and has been successfully used for industrial a...

This paper presents the results of theoretical studies process wear technological surfaces saw gin grates. Mathematical expressions are obtained, with help which it is possible to determine statistical characteristics raw roller and indicated that grate, in operation from impact roller, occurs as a result abrasive deposited on it. A rod model interaction between grate has also been studied, bas...