We sought to evaluate immediate and delayed micro-tensile bond strength of Panavia F2.0 and Multilink Sprint resin cement to superficial, deep and cervical dentin. Thirty-six freshly extracted non-carious human molars were sectioned in the mesiodistal direction to expose three different dentin regions including superficial dentin (1 mm below the dentine-enamel junction), deep dentin (1 mm above...

This review paper aims at reporting some of the notable works carried out concerning the use of nanoparticles (NPs) as a means of improving the resistance of fiber-reinforced polymer composite materials (FRPs) and adhesively bonded joints (ABJs) to delamination initiation and propagation. Applications of various nanoparticles, such as carbon-based, ceramic-based and mineral-based are discussed....

Conservative clinical solutions, predictable esthetic, and immediate outcomes are important concepts of restorative dentistry. The aim of this case study was to recognize the selective enamel removal as an interesting conservative alternative to achieve optimal esthetic results and discuss the clinical protocol. This clinical report described an alternative esthetic and conservative treatment t...

COMPARING THEVERTICAL MISFIT OF CASTS PRODUCED BY TWO VERFICATION JIGS Abdulaziz Alqahtani, B.D.S. Marquette University, 2014 Purpose: To compare the dimensional accuracy between master casts fabricated with verification jigs made of acrylic resin and light cure Triad. Materials and Methods: 10 GC Pattern resin Pattern verifications jigs and 10 Triad gel verification jigs fabricated of a master...

The inability to consistently achieve a passive fit with screw-retained implant prostheses is well documented in the literature. Cement-retained implant frameworks have been advocated for implant-retained fixed partial dentures. However, cement retention has not been routinely advocated for fixed-detachable hybrid prostheses. This article describes a method for fabricating a cement-retained fix...

Ceramic fractures are serious and costly problems in dentistry. Moreover, they pose an aesthetic and functional dilemma both for the patient and the dentist. This problem has created demand for the development of practical repair options which do not necessitate the removal and remake of the entire restoration. Published literature on repair techniques for fractured fixed partial dentures, conc...

In vitro tensile bond strengths were determined for three adhesive cements and two resin-bonded bridge cements to two alloys, each prepared by two methods: sandblasted Ni-Cr-Be alloy (I), electro-etched Ni-Cr-Be alloy (II), sandblasted Type IV gold alloy (III), and tin-plated Type IV gold alloy (IV). Storage conditions of 24 hours at 37 degrees C and 30 days at 70 degrees C were evaluated. The ...

Rapid prototyping (RP) process is inherently performed by layered manufacturing. The surface finish of the RP part is inevitably excessively rough. In this study, aluminum filled epoxy resin is used as a filler to improve surface quality of wax injection tool fabricated by fused deposition modeling. The average surface roughness of wax patterns can be drastically reduced from 1710 μm to 276 μm....

This investigation aims at determining the microhardness value of the hybrid direct/indirect composite resins submitted to conventional light curing and post-cured using two different methods, a light source from a laboratory light curing unit and a conventional oven heating, and the obtained results were compare to an indirect composite resin. A hybrid direct/indirect composite resin (Filtek P...

The objective of this study was to investigate the potential use of sand washing waste as filler for epoxy resin mortar. The mechanical properties of four series of mortars containing epoxy binder at 10, 15, 20, and 25 wt. % mixed with sand blended with sand washing waste filler in the range of 0-20 wt. % were examined. The compressive and flexural strength increased with the increase in epoxy ...