In this paper, the average heat transfer characteristics for a cross flow cylinder of 16 mm diameter in a vertical pipe has been studied for single-phase flow (water/oil) and multicomponent (non-boiling) flow (water-air, water-oil, oil-air and water-oil-air). The cylinder is uniformly heated by electrical heater placed at the centre of the element. The results show that the values of average he...

To assess the ability of the nose to warm and humidify inhaled air, we developed a nasopharyngeal probe and measured the temperature and humidity of air exiting the nasal cavity. We delivered cold, dry air (19-1 degrees C, <10% relative humidity) or hot, humid air (37 degrees C, >90% relative humidity) to the nose via a nasal mask at flow rates of 5, 10, and 20 l/min. We used a water gradient a...

The Effect of Carbon Dioxide Inhalation on Cerebral Blood Flow: A Two-Hour Duration Study in Dogs With Microspheres • Dogs breathed one of four gas mixtures (5% CO2-95% O2, 5% CO2-95% air, 10% CO2-90% O2, and 10% CO2-90% air) for as long as two hours. Regional cerebral blood flow as well as flow in nasal, otic, pituitary and skin tissue were measured by means of 15 ± 5 // radioactively labeled ...

ASSESSMENT OF FRACTIONAL EXPIRED GASES AND AIR FLOW BY AN AMBULATORY METABOLIC ANALYZER. PATRICK L. JACOBS, MARK S. NASH AND C. DAVID MINTZ. JEPONLINE, 1999, 2(4):2028. Fractional expired oxygen (FEO2) and carbon dioxide (FECO2), and air volume flow were compared using an ambulatory metabolic analyzer (KB1-C, Aerosport, Inc.) and a laboratory metabolic analyzer (Horizon MMC, Sensormedics, Inc.)...

A numerical model is developed to simulate the transport phenomena in the flow channel between parallel plates with porous and non-porous (or impermeable) walls. The continuity and momentum equations were solved first, assuming the wall Reynolds number in the range of with the suction or injection of air at a speed equal to the uniform inlet velocity. The results show that at constant inlet and...

In this study, granulated sludge synthesized in a sequence batch reactor (SBR) and then granulated sludge was transferred to continuous feeding and intermittent discharge (CFID) bioreactor. Two independent variables (air flow rate and hydraulic retention time (HRT)) were considered to optimize the process. Subsequently, long term performance (150 days) of the bioreactor was assessed by monitori...

A high pressure combined air-fuel injection system is designed and tested for an experimental free liquid-piston engine compressor. The application discussed utilizes available high pressure air from the compressor’s reservoir, and high pressure fuel to mix and then inject into a combustion chamber. This paper addresses the modeling, design and control for this particular high-pressure air-fuel...

The present paper was concerned primarily with the analysis, simulation of the air flow and thermal patterns in a lecture room. The paper is devoted to numerically investigate the influence of location and number of ventilation and air conditioning supply and extracts openings on air flow properties in a lecture room. The work focuses on air flow patterns, thermal behaviour in lecture room wher...

In air/oil lubrication systems, the flow parameters, e.g., flow pattern, liquid film thickness, and air/oil flow rate, are of great importance to the transportation efficiency. In most cases, the on-going two-phase flow is annular flow with the oil moving along the tube wall and the air travelling at high speed in the center. This usually results in the formation of a thin oil film, the thickne...