this research, presents mathematical modeling of drying process of aloe vera slices with dimensions of 7×4×0.5±0.1 cm. peeled aloe vera slices with the initial moisture content of 5750% (d.b) were osmosed for 5 hours in nacl solution of 10% and temperature of 40 °c at a constant solution to fruit ratio of 5:1. osmosed and unosmosed aloe vera samples were hot air dried at 55, 70 and 85°c with di...

The effect of various humidities on process yields and degrees of crystallinity for spray-dried powders from spray drying of lactose with humid air in a straight-through system have been studied. It has been suggested by Williams–Landel–Ferry kinetics (WLF) that a higher particle temperature and lower glass-transition temperature would increase the crystallization rate of the particles during t...

Spray drying is a process widely used to produce fruit juice powders. In powders, it results with the good quality, low water activity, easier transport and storage. The physicochemical properties of powders produced by spray drying depend on the variables of process and/or operating parameters. In the present review, the principle of spray drying was described. In addition, some factors such a...

In this study, an air heated solar collector (AHSC) dryer was designed to determine the drying characteristics of the pear. Flat pear slices of 10 mm thickness were used in the experiments. The pears were dried both in the AHSC dryer and under the sun. Panel glass temperature, panel floor temperature, panel inlet temperature, panel outlet temperature, drying cabinet inlet temperature, drying ca...

Objective: Drying is one of the most important post-harvesting processes in agriculture. Drying method and also drying time have an important effect on the amount of energy required. In this study analysis of energy consumption for drying corn in dryer reservoir with flow of warm air and the effect of the temperature and height of product layer on the amount of energy consumption per unit mass ...

Objective: Drying is one of the most important post-harvesting processes in agriculture. Drying method and also drying time have an important effect on the amount of energy required. In this study analysis of energy consumption for drying corn in dryer reservoir with flow of warm air and the effect of the temperature and height of product layer on the amount of energy consumption per unit mass ...

in this article we review the application and procedures involved in scanning electron microscope (sem) to observe biological and live tissues through using sem at high resolution. we discuss practical methods for optimizing tissue preservation to achieve the two principal goals of biological specimen preparation: (a) preserving biological structures as close to their living configuration as po...

The objective of this study was to determine the drying behavior of 2-phase olive mill waste (2POMW) under isothermal microwave-convection drying conditions. 2POMW samples were dried in a thin layer in a variable-power pilot microwave oven with impinging air, using a feedback controller to maintain sample temperature at one of four levels. Moisture loss and shrinkage of the samples were recorde...