The control of variable speed wind turbines is a complex problem since they are considered as nonlinear and time varying systems. In general, classical control techniques do not take into consideration the stochastic and dynamical aspect of the wind and they are not very robust. In order to address these weaknesses, neural approaches are proposed: a direct neural model DNM of the wind turbine i...

Traditional wind turbine control algorithms attempt to maximize power capture at low speeds and maintain rated power at high wind speeds. Active power control refers to a mode of operation where the turbine tracks a desired power reference command. Active power control enables wind farms to perform frequency regulation and to provide ancillary services in the energy markets. This paper presents...

Uncontrolled wind turbine configuration, such as stall-regulation captures, energy relative to the amount of wind speed. This configuration requires constant turbine speed because the generator that is being directly coupled is also connected to a fixed-frequency utility grid. In extremely strong wind conditions, only a fraction of available energy is captured. Plants designed with such a confi...

A frequent challenge for wind energy applications is to grasp the impacts of turbulent wind fields properly. The wind turbine power performance curve, usually determined applying the IEC standard 61400-12, provides a functional relation between the measured wind speed u and the corresponding power output P of the turbine. But it is not sufficient to describe the actual dynamics of the power out...

This paper studies a control strategy to improve low voltage ride through (LVRT) capability of doubly fed induction generator (DFIG)-based wind turbine (WT). This solution is based on the DFIG with Crowbar circuit control and the installation of STATCOM which is connected at the point of common coupling (PCC). The simulation model of WTs with STATCOM is built using the environment MATLAB/Simuli...

This paper focuses on the turbine-generator shaft models of double-cage Induction Generator (IG) based wind farm and its influence on the sub-synchronous resonance phenomenon. For this purpose, six different shaft models as 6-mass, 4-mass, 3-mass I, 3-mass II, 2-mass and 1-mass models are considered for double-cage IG wind-turbine. By using the linear modal analysis method, the effects of the d...

This paper is focusing on designing a control system for wind turbine which can control the speed and output power according to arbitrary algorithm. Reference Tracking Method is used to control the turbine spinning speed in order to increase its output energy. Keywords—Wind Turbine, Simulink, Reference Tracking Method.

In this research the behavior of small-scaled wind turbine system is evaluated against strong wind input considering round trip delay. Generally, the wind turbine system is generating energy from the revolution of blades. The revolution of blades is depended on the velocity of wind. Therefore, if there is strong wind then the revolution of blade is increased and more energy will generated. Ther...

Individual wind turbines, whether stand alone or in a wind farms, typically operate to maximize their own production without considering the impact of wake effects on nearby turbines. Investigation into wind turbine interaction within a wind farm has the potential to increase total power and reduce structural loads by properly coordinating the individual turbines that comprise the wind farm. To...

This thesis deals with the analysis, modeling, and control of the doubly-fed induction generator (DFIG) for wind turbines. Different rotor current control methods are investigated with the objective of eliminating the influence of the back electromotive force (EMF), which is that of, in control terminology, a load disturbance, on the rotor current. It is found that the method that utilizes both...