Aerosol particle measurements in the atmospheric boundary layer performed by a helicopter-borne measurement payload and by a lidar system from a case study during the IMPACT field campaign in Cabauw (NL) are presented. Layers of increased number concentrations of ultrafine particles were observed in the residual layer, indicating relatively recent new-particle formation. These layers were chara...

To evaluate the effects of lung disease on deposition of inhaled ultrafine particles (less than 0.1 micron diameter), we measured total respiratory tract deposition of nonhygroscopic particles of 0.02 to 0.24 micron in five subjects with obstructive lung disease and three subjects with restrictive lung disease and compared it with that in ten normal subjects. Deposition was measured as concentr...

Dynamic recrystallization (DRX) is an important grain refinement mechanism to fabricate steels with high strength and high ductility (toughness). The conventional DRX mechanism has reached the limitation of refining grains to several microns even though employing high-strain deformation. Here we show a DRX phenomenon occurring in the dynamically transformed (DT) ferrite, by which the required s...

Aerogels are used in a broad range of scientific and industrial applications due to their large surface areas, ultrafine pore sizes, and extremely low densities. Recently, a large number of reports have described graphene aerogels based on the reduction of graphene oxide (GO). Though these GO-based aerogels represent a considerable advance relative to traditional carbon aerogels, they remain si...

OBJECTIVE Coronary heart disease (CHD) is the primary cause of death among US firefighters during fire suppression. In other populations, exposure to respirable particles, including ultrafine particles, has been widely implicated as a risk factor for CHD. This study is the first to report detailed characterization of respirable particles released by combustion of an automobile and model residen...

True stress (·)­true strain (3⁄4) relationships until just before fracture, i.e., the plastic deformation limit, were estimated by the stepwise tensile test and the Bridgman equation for various metals and alloys with different crystal structures. The estimated ·­3⁄4 relationships were different from the nominal stress­strain curves including the conventional tensile properties. In the relation...

…………………………………………………………………………………………...vii Executive Summary……………………………………………………………………………...viii Introduction………………………………………………………………………………………...1 Task 1 report…………………………………………………………………………………….....3 Development and application of a transportable ambient aerosol concentrator and exposure facility suitable for human exposure to coarse, fine, and ultrafine particles Task 2 report……………………………………………………...

Electrospinning has been recognized as an efficient technique for the fabrication of polymer nanofibers. Various polymers have been successfully electrospun into ultrafine fibers in recent years mostly in solvent solution and some in melt form. Potential applications based on such fibers specifically their use as reinforcement in nanocomposite development have been realized. In this paper, a co...

Particle number concentration and particle size are the two key parameters used to characterize exposure to airborne nanoparticles or ultrafine particles that have attracted the most attention. This paper proposes a simple micro aerosol sensor for detecting the number concentration and particle size of ultrafine particles with diameters from 50 to 253 nm based on electrical diffusion charging. ...

Unraveling the atomic structures of ultrafine iron clusters is critical to understanding their size-dependent catalytic effects and electronic properties. Here, we describe the stable close-packed structure of ultrafine Fe clusters for the first time, thanks to the superior properties of graphene, including the monolayer thickness, chemical inertness, mechanical strength, electrical and thermal...