The target was to study and develop industrially suitable methods to apply thermoplastic coatings on plywood. Typically, wear and climatic resistance for wooden sheets, such as chip board and plywood, is achieved by thermosetting resin coating (e.g. phenolformaldehyde). However, economical and environmental issues are driving towards thermoplastic coatings (e.g. polyethylene) in such products. ...

Seed enhancement methods are applied to eliminate or decrease adverse environmental stresses effects and increase seed germination rate and vigor of rangeland plants. The aim of this study was to assess different methods of seed coating effects on germination speed of Onobrychis sativa at different sowing depths and soil moisture levels. The experiment was conducted at growth chamber to apply a...

Problem statement: Dammar is a natural resin that used anciently in varnish production. The use of dammar natural resin in coating is limited by undesirable properties for application in coating where it is considered very brittle. Due to dammar's brittle nature, an aged dammar coating can be easily scratched or abraded. Approach: Dammar natural resin could be modified into SiliconeDammar by us...

In an internal combustion engine, the heat energy approximately one third of total fuel input energy is converted to useful work. Since the exhaust gas temperature is not equal environmental temperature, so lot of heat energy lost with hot gases. Also heat energy is lost in cooling of engine. If we recovered heat energy which lost in cooling instead on crankshaft as useful work, then increase t...

In this study, the effect of deposition regime on the wear behavior of VK8 coating applied to 1.2344 tool steel by electro spark method (ESA) was investigated. After sample preparation, the coating with high and low regime was applied. To assess the wear behavior, the pin on disk test method according to ASTM G99-04, was used. For surveying surface morphology and cross section of the coating as...

In the present study, Thermo-Reactive Deposition method (TRD) in a molten bath was used to form niobium carbide coating on AISI L2 steel. The coating was formed in five different composition of borax (Na2B4O7), boric acid (B2O3), and ferro-niobium. For all of the five compositions of molten bath, niobium carbide coating treatment was carried out at 1173 K, 1273 K, and 1373 K for 2, 4 and 8 hour...

Drug-eluting stents (DES) are commonly used in coronary angioplasty procedures. A DES elutes drug compounds from a thin polymeric coating into the surrounding coronary artery tissue to reduce in-stent restenosis (a significant lumen loss due to growth of vascular tissue). Biodurable (non-erodible) polymers are often used in the current DES coatings, which stay permanently in the patients. While...

D. Niblett, S. C. Porter, I. Gabbott, G. Reynolds, T. Morgan, K. Karan, J. Greenamoyer, R. Hach University of Manchester, Ashland Specialty Ingredients, AstraZeneca Purpose Aqueous film coating still remains a complex process in which the process parameters selected can have a major impact on ultimate product quality. In this study, a wide range of processing parameters was performed in order t...

Measurements of the optical mirror coating properties. Abstract The results of measurement of optical mirror coating are presented. These results indicate that Standard Quantum Limit of sensitivity can be reached in the second stage of LIGO project if it is limited by thermoelastic noise in the coating only.