Data obtained from Nary calibration tests of an 18-cylinder, two-row, radial engine of 8350-cubic-inch displacement and a 14-cylinder, two-row, radial engine of 2600-cubic-inch displacement {carburetor types) were analyzed to show the correlation between the air consumption of these engines and the parameters that evaluate the air consumption from intake-manifold temperature and pressure, exhau...

In traditional lucky imaging (TLI), many consecutive images of the same scene are taken with a high frame-rate camera, and all but sharpest discarded before constructing final shift-and-add image. Here we present an alternative image analysis pipeline -- The Thresher for these kinds data, based on online multi-frame blind deconvolution. It makes use available data to obtain best estimate astron...

This paper deals with the experimental investigations of the in-cylinder tumble flows in an unfired internal combustion engine with a flat piston at the engine speeds ranging from 400 to 1000 rev/min., and also with the dome and dome-cavity pistons at an engine speed of 1000 rev/min., using particle image velocimetry. From the two-dimensional in-cylinder flow measurements, tumble flow analysis ...

In this article, the fluid forces and the dynamics of a flexible clamped-clamped cylinder in turbulent axial flow are computed numerically. In the presented numerical model, there is no need to tune parameters for each specific case or to obtain coefficients from experiments. The results are compared with the dynamics measured in experiments available in literature. The specific case studied he...

This paper reports a study on the effect of helical, spiral, and helical-spiral combination manifold configuration on air motion and turbulence inside the cylinder of a Direct Injection (DI) diesel engine motored at 3000 rpm. Three-dimensional model of the manifolds and the cylinder is created and meshed using the pre-processor GAMBIT. The flow characteristics of these engine manifolds are exam...

We study the interface dynamics of a binary particle mixture in a rotating cylinder numerically. By considering only the particle motion in axial direction, it is shown that the initial dynamics can be well described by a one-dimensional diffusion process. This allows us to calculate a macroscopic diffusion constant and we study its dependence on the inter-particle friction coefficient, the rot...

With the aim of circumventing challenges faced farmers in soya bean threshing operation a demonstration new thresher was conducted Guto Gida and Ayana woredas total four kebeles. The demonstrated at farmer training center as well on farmers’ field evaluated for its performance against existing practices by sixty participating both sexes who were members farmer’s research groups. All valuable da...

A model based control scheme is designed to regu late the cylinder air charge of a camless multicylinder engine for unthrottled operation The controller con sists of a feedforward and an adaptive feedback scheme based on a control oriented model of the breathing process of an engine equipped with electro hydraulic springless valve train The nonlinear control scheme is designed to achieve cylind...

In this paper we have investigated a circular band formation of fluid-rigid-particle mixtures in a fully filled cylinder horizontally rotating about its cylinder axis by direct numerical simulation. These phenomena are modeled by the Navier-Stokes equations coupled to the Euler-Newton equations describing the rigid solid motion of the non-neutrally particles. The formation of circular bands stu...

Chamber tests of simulated electrodynamic tethers (EDTs) of different geometries operating in a dense high-speed plasma are described. The geometries tested and described here are cylindrical and flat-ribbon tape. By moving the probe samples relative to the plasma source it was possible to vary the density and therefore the effective width over a range of approximately 1 to 2 Debye lengths ( ) ...