The scalable chemical vapor deposition of monolayer hexagonal boron nitride (h-BN) single crystals, with lateral dimensions of ∼0.3 mm, and of continuous h-BN monolayer films with large domain sizes (>25 μm) is demonstrated via an admixture of Si to Fe catalyst films. A simple thin-film Fe/SiO2/Si catalyst system is used to show that controlled Si diffusion into the Fe catalyst allows exclusive...

We report a new strategy towards the control of carbon nanotube (CNT) structure and continuous fibre formation using a floating catalyst direct spinning CVD process. In the procedures used to date, a sulphur promoter precursor is added to significantly enhance the rate of CNT formation in the floating catalyst synthesis. Within the reaction zone, the rapidly grown nanotubes self-assemble into b...

Proton exchangemembrane fuel cells are promising candidates for a clean and efficient energy conversion in the future, the development of carbon based inexpensive non-precious metal ORR catalyst has becoming one of the most attractive topics in fuel cell field. Herein we report a Feand Ndoped carbon catalyst Fe-PANI/C-Mela with graphene structure and the surface area up to 702 m g. In 0.1 MHClO...

A DFT modeling of the transition state of oxidative dehydrogenation of ethylbenzene over zirconium vanadate catalyst has been carried out. Computations confirm a Mars-Van-Krevelen type redox mechanism in which the catalyst abstracts a hydrogen atom from the hydrocarbon and catalyst is reduced. The reduced catalyst is reoxidized by oxygen from air. Computations suggest the formation of a hydroxy...

Nickel oxide (NiO) and phosphotungstic acid (PTA) supported on a ZIF-8 (NiO-PTA/ZIF-8) catalyst was first synthesized and it showed high activity and good selectivity for the hydrocracking of Jatropha oil. The catalyst was characterized by SEM, SEM-EDS, TEM, N2 adsorption, FT-IR, XRD and XPS. Compared with the NiO-PTA/Al2O3 catalyst, the selectivity of C15-C18 hydrocarbon increased over 36%, an...

A new non-precious metal oxygen reduction catalyst was developed via heat treatment of in situ polymerized polyaniline onto TiO(2) particles in the presence of Fe species. The TiO(2) provides for improved performance relative to a carbon black-based catalyst and, at a high catalyst loading, allows for reducing the performance gap between non-precious-metal catalyst and Pt/C to ca. 20 mV in RDE ...

Experiments of propane and propene steam reforming have been performed over a Pd–Cu/c-Al2O3 catalyst and over a Ni/NiAl2O4 catalyst. Over the palladium-based catalyst, the steam reforming of propene is faster and more selective than steam reforming of propane. Over the Pd catalyst, the steam reforming of propane is likely inhibited by site poisoning. In contrast, over Ni-based catalyst the refo...

A compound catalyst (RA) consisted of Ni, ZnO and HZSM-5 with functions of reactive adsorption desulfurization (RADS) and olefin aromatization for fluid catalytic cracking (FCC) gasoline upgrading was prepared. X-ray powder diffraction (XRD), temperature-programmed reduction and low-temperature N2 adsorption were used to characterize the properties of the catalysts. Performance evaluation by FC...

This paper describes active control of an aftertreatment system for a spark ignition engine equipped with a three-way catalyst and preand post-catalyst oxygen sensors. The control objective is to maximize the simultaneous conversion efficiencies of oxides of nitrogen and unburned hydrocarbons. Linear exhaust gas oxygen sensors are used to measure preand post-catalyst air-fuel ratio. A series co...

the esterification of free fatty acids (ffa) with methanol is studied using sulfonated porous carbon (spc) as catalyst. in compare to the amorphous sugar catalyst and protonated nafion, the proposed catalyst shows stability and high efficient performance in biodiesel production. the highest initial rate of oleic acid conversion is obtained at catalyst loading of 1 mmol h+ and mole ratio of meoh...