In this paper, nonlinear phenomena appearing in DC-DC converters are analyzed by using a discrete time nonlinear map (the A-switching map). We then propose a feedback control method improving switch-mode power supplies electromagnetic compatibility (spectral peaks compliance). To confirm the efficiency of this new and simple method, the map is derived in closed form from the system of nonlinear...

In this work, a method is given to compute the switching angles in a multilevel converter to produce the required fundamental voltage while at the same time cancel out specified higher order harmonics. Specifically, a complete analysis is given for a seven-level converter (three dc sources), where it is shown that for a range of the modulation index , the switching angles can be chosen to produ...

This paper presents the hybrid seven-level cascaded active neutral-point-clamped (ANPC)-based multilevel converter. The converter topology is the cascaded connection of a three-level ANPC converter and an H-bridge per phase. The proposed topology provides a tradeoff between different component counts to achieve a good loss distribution, avoid direct series connection of semiconductor devices, k...

This paper proposes a new high step-up DC–DC converter designed especially for regulating the dc interface between various micro sources and a dc–ac inverter to electricity grid. The need of Electricity increases the power demand where the power demand met by the conventional sources of energy has some disadvantage of pollution, this disadvantage can be decreased by the use of the Renewable ene...

Pulse Width Modulated (PWM) Rectifiers offer a promising and high end performance for the ac to dc conversion needs of the industry, customer and power grid sectors. This paper presents a reduced switching loss algorithm applied to a hysteresis current controlled PWM rectifier. This acts as an ac to dc boost converter with near unity power factor at the grid side along with regulated and ripple...

The small-signal modeling technique based on the extended describing function concept is applied to LCC resonant converters. The analytical model developed includes both frequency control and phase-shift control. The small-signal equivalent circuit models are also derived and implemented in PSPICE. The models are in good agreement with the measurement data. 1. INTRODUCTION An LCC resonant conve...

This work presents a novel highly efficient and low-stress battery charger with a resonant switch converter— based on resonance and zero-voltage-transition soft-switching theory—that reduces defects associated with high voltage and high current stresses caused by the resonance of traditional resonant circuits. The novel battery charger meets the requirement that all circuit components must oper...

The application of MATLAB/SIMULINK is developed for simulation and learning feedback controller design of dc–dc switching converters. With the help of its intuitive graphical user interface and some basic circuit theories, the corresponding SIMULINK models of the switching converter circuits can be easily constructed. Students can then use these models to learn and evaluate the closed-loop beha...

-In this paper, comparative evaluation of different techniques for harmonic reduction in input current of ac-dc converter is presented. Converters employing ac side switching, resonant converter, active clamped boost converter are simulated in PSIM and their performance under varying load condition with load voltage regulation is evaluated. The results revealed that active clamped boost convert...

This paper presents the development of a DC-DC boost converter. In the proposed boost converter design, a passive regenerative snubber circuit is included to absorb the energy of stray inductance so as to reduce the IGBT switching losses. MATLAB simulation as well as an experiment results are conducted to validate the proposed device. The results show that the proposed boost converter design gi...