magnesium alloys as biodegradable materials can be used in body as an implant materials but since they have poor corrosion resistance, it is required to decrease their corrosion rate by biocompatible coatings. in this study, hydroxyapatite (ha) coatings in the presence of an intermediate layer of zrn as a biocompatible material, deposited on az91 magnesium alloy by ion beam sputtering method at...

An extremely sensitive dependence of the electronic properties of SnOx film on sputtering deposition power is discovered experimentally. The carrier transport sharply switches from n-type to p-type when the sputtering power increases by less than 2%. The best n-type carrier transport behavior is observed in thin-film transistors (TFTs) produced at a sputtering power just below a critical value ...

AlN thin films were deposited on flexible Hastelloy tapes and Si (100) substrate by middle-frequency magnetron sputtering. A layer of Y₂O₃ films was used as a buffer layer for the Hastelloy tapes. A two-step deposition technique was used to prepare the AlN films. The effects of deposition parameters such as sputtering power, N₂/Ar flow rate and sputtering pressure on the microstructure of the A...

AlN thin film was prepared over different metal substrates using DC sputtering at various sputtering parameters. The XRD spectra revealed the presence of mixed (cubic and hexagonal) phases for all samples other than samples prepared at 300W with Ar:N2 gas ratio of 14:6. The intensities of cubic phases observed at copper (Cu) substrates increased drastically with high sputtering power and N2 gas...

Calculations of the recoil energy under bombardment surface edge (001) for vanadium mono-crystal by K + ions (E_0=10-50 eV) with initial motion trajectories lying in planes perpendicular to plane and parallel (100) (110), passing along crystallographic directions [010] [110], respectively, have been made method molecular dynamics using a long-range interaction potential. Anisotropy maximum tran...

a cylindrical direct current magnetron sputtering coater with two targets for deposition of multilayer thin films and cermet solar selective surfaces has been constructed. the substrate holder was able to rotate around the target for obtaining the uniform layer and separated multilayer phases. the al/ cu multilayer film was deposited on the glass substrate at the following conditions: working g...

In this work, Ga-doped ZnO (GZO) thin films were deposited via radio frequency sputtering at room temperature. The influence of the Ga content on the film's optoelectronic properties as well as the film's electrical stability were investigated. The results showed that the film's crystallinity degraded with increasing Ga content. The film's conductivity was first enhanced due to the replacement ...

Amorphous Si (a-Si) films with metal silicide are expected to enhance the absorption ability of pure a-Si films. In this present study, NiSi (20 nm)/Si (40 nm) and AlSi (20 nm)/Si (40 nm) bilayer thin films are deposited through radio frequency (RF) sputtering at room temperature. The influence of the film's composition and the annealing temperature on the film's optical absorption is investiga...