We address the problem of H 1 gain-scheduling of a magnetic bearing/rotor system with the speed of the rotor being the scheduling parameter. The rotor exhibits signiicant gyroscopics. As a result, the plant dynamics change with the rotor speed. Recent results in the theory of LPV systems can be used to design robust, gain-scheduled controllers for such a system. As opposed to traditional gain-s...

This paper presents two design-and-analysis cases of a linestart axial-flux permanent-magnet motor: with solid rotor and with composite rotor. For a novel structure of the motor, two concentric unilevel spaced raised rings are added to the inner and outer radii of its rotors to enable auto-start capability. The composite rotor was coated by a thin (0.05 mm) layer of copper. The basic equations ...

This study concerned the dynamic behavior of the wind turbine rotor. Before all we have studied the loads applied to the rotor, which allows the knowledge their effect on the fatigue, also studied the rotor with longitudinal crack in order to determine stress, strain and displacement. Firstly we compared the first six modes shapes between cracking and uncracking of HAWT rotor. Secondly we show ...

In this paper, a novel doubly excited brushless generator (DEBG) with outer radial laminated magnetic barrier rotor (RLMB-rotor) for wind power application was designed and analyzed. The DEBG has 10 rotor pole numbers with outer rotor. Its performance was investigated using the 2D transient finite element method. The magnetic fields, torque capability, end winding voltage characteristics, radia...

Abstract : This paper proposes a speed tracking control of induction motors based on the inpuVoutput linearization method, which can also achieve the maximal power transfer. A simple group of observers are designed to estimate the rotor flux in order to determine the orientation of rotor flux. The control law of the maximal power transfer to the rotor gives the relationship between the stator v...

in this paper, the unified power flow controller (upfc) is enhanced with a chaotic particle swarm optimization (cpso) damping controller in order to mitigate the low frequency oscillations (lfo) in a single machine infinite bus (smib) power system. the designed damping controller is an optimized lead-lag controller, which extracts the speed deviation of the generator rotor and generates the out...

One of the major disadvantages of centrifugal elutriation (CE) is the relatively large volume (150 ml) of the various fractions, especially if small numbers of cells have to be separated and the fractions contain few cells. To reduce the volume of the fractions 2 elutriator rotors were coupled in series. Since the rotor speed of the second rotor was always kept 750 rpm higher than that of the f...

Modern utility-scale wind turbines are typically controlled using yaw, generator torque, and blade pitch actuation (Pao and Johnson, 2011). The yaw motor is used to align the rotor with the wind direction for the purpose of maximizing power capture. Generator torque is controlled during below-rated (region 2) operation to maximize power capture by maintaining the optimal tip speed ratio. In abo...

Wind power is sustainable and prevalent virtually all over the globe. However, conversion efficiency of conventional single-rotor wind turbine (SRWT) still far from satisfactory. The dual-rotor counter-rotating concept among reliable techniques used to enhance a energy device for its renowned effectiveness. This study aims investigate performance Savonius dual/twin-rotor system, particularly in...

Squeeze Film Dampers (SFD) are commonly used for passive vibration control of rotor-bearing systems. The Magnetorheological (MR) and Electrorheological (ER) fluids in SFDs give a varying damping characteristic to the bearing that can provide active control schemes for the rotor-bearing system. A common way to model an MR bearing is implementing the Bingham plastic model. Adding this model to th...