In dispersive readout schemes, qubit-induced nonlinearity typically limits the measurement fidelity by reducing the signal-to-noise ratio (SNR) when the measurement power is increased. Contrary to seeing the nonlinearity as a problem, here we propose to use it to our advantage in a regime where it can increase the SNR. We show analytically that such a regime exists if the qubit has a many-level...

This papers investigates underlying mechanisms for human response to wind turbine noise by studying the effects in terms of source detection, recognition and annoyance with and without road traffic noise. Recordings from a single 1.8-MW wind turbine have been mixed with samples of highway noise and of local roads at different signalto-noise ratios. These fragments have been presented to 50 norm...

As an active remote sensing instrument, lidar provides a high spatial resolution vertical profile of aerosol optical properties. But the effective range and data reliability are often limited by various noises. Performing a proper denoising method will improve the quality of the signals obtained. The denoising method based on ensemble empirical mode decomposition (EEMD) is introduced, but the d...

The EKT method is a recent extraction technique of periodic signals from noise. It is a method presenting a great practical interest because of its easy realization and its high signal-to-noise ratio (SNR)—higher than that of the averaging method. However, it is only valid for signals of known period. Since in practice, periods are not always known with good precision, the EKT method remains li...

The issues of validity and reliability are important in forensic science. Within the likelihood-ratio framework for the evaluation of forensic evidence, the log-likelihood-ratio cost (Cllr) has been applied as an appropriate metric for evaluating the accuracy of the output of a forensic-voice-comparison system, but there has been little research on developing a quantitative metric of precision....

We report an investigation of the perception of American English phonemes by Dutch listeners proficient in English. Listeners identified either the consonant or the vowel in most possible English CV and VC syllables. The syllables were embedded in multispeaker babble at three signal-to-noise ratios (16 dB, 8 dB, and 0 dB). Effects of signal-to-noise ratio on vowel and consonant identification a...

Frame-based regularization method as one kind of sparsity representation method has been developed in recent years and has been proved to be an efficient method for CT image reconstruction. However, most of the developed CT image reconstruction methods are analysis-based frame methods. This paper proposes a novel frame-based balanced hybrid model with two sparse regularization terms for CT imag...

In this paper, we investigate the influence of carrier phase jitter on the performance of an OFDM/CDMA system. This carrier phase jitter reduces the performance of the system, defined as the signal-to-noise ratio at the input of the decision device. When all users have the same power level and phase jitter spectrum, it is shown that for the highest load, the degradation only depends on the jitt...