We demonstrate the operation of a radio-frequency single-electron transistor (RF-SET) using single-wall carbon nanotubes (SWNTs). The device is embedded in a resonant tank circuit and operates in reflection mode at temperatures as high as 5 K. Both frequency domain and time domain results are presented. With a gate modulation frequency of 1 MHz, a charge sensitivity of ∼4.78 × 10−4e/Hz−1/2 is o...

In this paper, high-frequency (HF) AC and noise modeling of MOSFETs for radio frequency (RF) integrated circuit (IC) design is discussed. A subcircuit RF model incorporating the HF effects of parasitics is presented. This model is compared with the measured data for both parameter and characteristics. Good model accuracy is achieved against measurements for a 0.25 m RF CMOS technology. The HF n...

A 120-GHz-band close-proximity wireless system that achieves the first 10-Gbit/s real-time transmission satisfying the regulation for extremely low-power radio stations (ELRS regulation). The use of photonic technologies enables the transmitter to perform 10-Gbit/s quadrature-phase-shift keying (QPSK) modulation and generate an RF spectrum with negligibly small spurious signals. The phase of th...

Future communication needs to be ubiquitous, broadband, convergent, and seamless. Radio over fiber (RoF) technology is one of the most important enabler in access network for the technologies. Adoption of RoF faces bottleneck in optoelectronics, that they are still expensive, high power consumption, and limited in bandwidth. To solve the problem, transceiver in remote antenna unit (RAU) is deve...

Recently deep submicron and SiGe (silicongermanium) bipolar CMOS technologies have enhanced the performance of Si-based radio frequency (RF) integrated circuits up to microwave frequencies. The integration of RF MEMS components, such as inductors and capacitors, could further improve the performance of key RF circuit blocks such as voltage controlled oscillators (VCO), low-noise amplifiers, fil...

Wireless mesh network addresses the last mile issue. This technology utilizes radio frequency (RF). The practical limitations and challenges of RF based communication networks have become increasingly apparent over the past decade, leading researchers to seek new hybrid communication approaches. One promising strategy that has been the subject of considerable interest is the augmentation of RF ...

The photocathode radio-frequency (RF) gun is a powerful electron source to generate a high-brightness femtosecond electron beam with energies of 1~3 MeV. The RF gun based relativistic ultrafast electron diffraction (UED) is a promising new technique that has the potential to probe directly structural changes at the atomic scale with sub-100 fs temporal resolution. In this paper, we analyze the ...

Radio-frequency (RF) circuits exhibit several distinguishing characteristics that make them difficult to simulate using traditional SPICE transient analysis. The various extensions to the harmonic balance and shooting method simulation algorithms are able to exploit these characteristics to provide rapid and accurate simulation for these circuits. This paper is an introduction to RF simulation ...

Bandpass sampling algorithm is effectively adopted to obtain the digital signal with significantly reduced sampling rate for a single radio frequency(RF) signal. In order to apply the concept to multiple RF signals, we propose bandpass sampling algorithms with the normal and the inverse placements since we are interested in uniform order of the spectrum in digital domain after bandpass sampling...

This paper proposes an active radio frequency (RF) cancellation solution to suppress the transmitter (TX) passband leakage signal in radio transceivers supporting simultaneous transmission and reception. The proposed technique is based on creating an opposite-phase baseband equivalent replica of the TX leakage signal in the transceiver digital front-end through adaptive nonlinear filtering of t...