This paper describes the three-phase grid-connected inverter model for photovoltaic application. The inverter system model and control strategies are carried in MATLAB/SIMULINK environment. Utilizing both proportional-integral controllers for the control loops, and the sinusoidal pulse-width modulation switching signals generation technique for the IGBTs, the inverter control system capable of ...

The paper presents a space-vector pulse width modulation (SVPWM) inverter feeding a permanent-magnet synchronous motor (PMSM). The SVPWM inverter enables to feed the motor with a higher voltage with low harmonic distortions than the conventional sinusoidal PWM inverter. The control strategy of the inverter is the voltage / frequency control method, which is based on the space-vector modulation ...

A fault tolerant structure and its corresponding control strategy for electromagnetic stirring power supplies are proposed in this paper. The topology structure of the electromagnetic stirring power supply contains two-stages. The fore-stage is the PWM rectifier. The back-stage is the fault tolerant inverter, which is a two-phase three-bridge orthogonal inverter circuit while operating normally...

In this paper a novel multilevel current source inverter structure is proposed. This inverter is likely to be used in low/medium power applications. The proposed topology is analyzed and then compared with conventional inverters in order to validate the superiority of the proposed inverter. In this topology, all the desired current levels can be obtained using lower number of circuit devices. T...

In this paper, an H-bridge inverter topology with reduced switch count technique is introduced. This technique reduces the number of controlled switches used in conventional multilevel inverter. To establish a single phase system, the proposed multilevel inverter requires one H-bridge and a multi conversion cell. A multi conversion cell consists of three equal voltage sources with three control...

Integration of fuel cell stack with an inverter is complex in nature. A number of factors have to be taken into account in designing the inverter as well as during the integration. One of these factors is ripple current which could affect the life of the fuel cell stack if there is fuel and/or oxidant starvation. In this paper an inverter topology is investigated which significantly reduces or ...

To eliminate the common-mode leakage current in the transformerless photovoltaic system, an improved high efficiency inverter H6 type configuration with Z-source is presented. The Z-source network can perform boost as well as sustained shoot through operation. Also, the improved transformer less inverter can sustain the same low input voltage as the full-bridge inverter and guarantee to complet...

In this paper, a new soft switching three phase inverter with a quasi-resonant dc-link is presented. The proposed inverter has a dc-link switch and an auxiliary switch. The inverter switches are turned on and off under zero voltage switching condition and all auxiliary circuit switches and diodes are also soft switched. The control utilizes PWM and the auxiliary switch does not require an isola...

An important part of uninterruptable power supply is the DC to AC inverter which converts the DC voltage from a battery to an AC voltage that is required to operate electronic circuits. These inverters are bulky in nature & consume most of the power. Therefore power available at the output of inverter is less. So it is the goal of this paper to develop a DC/AC inverter capable of producing a pu...

The superconducting magnetic levitation railway system (MAGLEV) under development in Japan uses a pulsewidth-modulation (PWM) inverter for driving a linear synchronous motor (LSM). The inverter output voltage contains non-negligible harmonics which cause harmonic resonances in the LSM system, and therefore harmonics of the output voltage have been analyzed in order to control such harmonic reso...