The overall heat transfer process within the in-cylinder for port injection hydrogen fueled internal combustion engine (H2ICE) has been investigated through simulation, while the experimental data has been utilized for validation purpose of the adopted numerical model. One-dimensional gas dynamics was used to describe the flow and heat transfer in the components of the engine model. The engine ...

The subject of this research is the sensorless control method verification an asynchronous motor by a simulation in area low speed (up to 5 Hz) via high-frequency analog signal injection method. implementation continuous simpler when compared with discrete injection; however, has more advantages processing. injected will be superimposed on main stator voltage. response manifested mainly based a...

Designing and manufacturing the multiple jets simulator and experimental investigation of the multiple jets in crossflow at low velocity ratios have been studied Together with design and build a low-speed wind tunnel. A specific rake is used to determine the flow field pressure and changes in static pressure measured by pressure taps in the near field of the jets. There are generally three regi...

Nowadays biodiesel is receiving more attention as a most important renewable energy for using in diesel engines. Inthis research, the application of Response Surface Methodology (RSM) was highlighted to investigate the effects of biodiesel-diesel blends (B0, B20, B50 and B100), engine operating parameters (engine load and  speed) on CO2 emission of a diesel engine. The experiments were conducte...

In this article, the effect of parameters like working gap, work piece rotational speed and material removal mechanism(injection of the SiC Abrasive slurry and Al2O3, use of diamond paste as abrasive tool) in Magnetic Abrasive Finishing process using designing of experiments on the external surface of Cylindrical work pieces of Stainless steel AISI 440C to get minimum surf...

In this article, the effect of parameters like working gap, work piece rotational speed and material removal mechanism(injection of the SiC Abrasive slurry and Al2O3, use of diamond paste as abrasive tool) in Magnetic Abrasive Finishing process using designing of experiments on the external surface of Cylindrical work pieces of Stainless steel AISI 440C to get minimum surf...

We generalize the noisy expectation-maximization (NEM) algorithm to allow arbitrary modes of noise injection besides just adding noise to the data. The noise must still satisfy a NEM positivity condition. This generalization includes the important special case of multiplicative noise injection. A generalized NEM theorem shows that all measurable modes of injecting noise will speed the average c...

The effects of three premedication regimens were compared in 45 healthy patients in whom anaesthesia was induced with diprivan 2 mgkg" I.V Premedication with diazepam 10 mg orally and droperidol 2.5-5 Omg and piritramide 7.5-15.0 mg i.m. resulted in less pain on injection and a more profound sleep from dipnvan than premedicanon with diazepam 10 mg orally or no premedication. No differences in s...

Abstract—The detection of the polymer melt state during manufacture process is regarded as an efficient way to control the molded part quality in advance. Online monitoring rheological property of polymer melt during processing procedure provides an approach to understand the melt state immediately. Rheological property reflects the polymer melt state at different processing parameters and is v...

This paper presents a feedback deign approach to the cold-start speed control for spark ignition engines. First, in order to ensure successful combustion in the transient mode, a fuel injection controller is given based on the air charge estimation with inverse dynamics of fuel path, which is a dual sampling rate system, i.e. the estimation for the air charge is performed TDC-based, and the fue...