in the continuous gas lift operation, compressed gas is injected into the lower section of tubing through annulus. the produced liquid flow rate is a function of gas injection rate and injection depth. all the equations to determine depth of injection assumes constant density for gas based on an average temperature of surface and bottomhole that decreases the accuracy of gas lift design. also g...

Three aspects, such as the optimization of calculation model for the minimum gas injection rate, the effect of elevation on the minimum gas injection rate, the effect of air humidity on the minimum gas injection rate, have been reviewed in this paper. Considering the influence of altitude and air humidity, correction factor for gas injection rate is calculated. The value of gas injection for al...

Air sparging (AS) is a commonly applied method for treating groundwater contaminated with volatile organic compounds (VOCs). When using a constant injection of air (continuous mode), a decline in remediation efficiency is often observed, resulting from insufficient mixing of contaminants at the pore scale. It is well known that turning the injection on and off (pulsed mode) may lead to a better...

oxides of nitrogen are the major emission from a diesel engine. it is due to heterogeneous diffusion combustion system with fuel-rich regions, which produce high local temperature around the periphery of the spray where high formation rate of no is promoted. various techniques are therefore employed to reduce the nox emission like egr, scr, etc. in this present work a rotating injector is a tec...

In this research attempts were made to estimate the in-situ stresses acting on a hydrocarbon reservoir based on routine activities of acid injection in oil reservoir. It was found that the relation between the re-opening pressure of fracture and principal in-situ stresses can be estimated using rock mechanics equations for the circular underground cavities. An appropriate relation between the m...

investigations are carried out to evaluate the performance of a low heat rejection (lhr) diesel engine consisting of air gap insulated piston with 3-mm air gap, with superni (an alloy of nickel) crown and air gap insulated liner with superni insert with different operating conditions of crude jatropha oil with varied injection timing and injection pressure.  performance parameters of brake ther...