the growth of the electrical energy consumption form one side and the bounded available fossil fuel and other limitations from the other side, makes the thermal power plants upgrading as a main demand in the world. decreasing the internal energy consumption, increasing the performance and the output power with the minimum costs are the important targets of the power plants retrofitting. nowaday...

This paper presents the exergy analysis and optimization of the Stirling engine, which has enormous potential for use in the renewable energy industry as it is quiet, efficient, and can operate with a variety of different heat sources and, therefore, has multi-fuel capabilities. This work aims to present a method that can be used by a Stirling engine designer to quickly and efficiently find nea...

A primary objective of the Engineered Barrier Design Test (EBDT) at the Yucca Mountain Exploratory Shaft Test Site is to examine how the variably saturated, fractured rock mass surrounding the waste package will respond hydrothermally to heating, cooling, and infiltration. The EBDT will include several partialand/or full-scale electrical heaters to simulate the thermal load generated by the was...

In the present work, an inverse analysis of combined radiation and laminar forced convection heat transfer in a two-dimensional channel with variable cross sections is performed. The conjugate gradient method is used to find the temperature distribution over the heater surface to satisfy the prescribed temperature and heat flux distributions over the design surface. The fluid is considered to b...

scanning hall probe microscopy (shpm) is a scanning probe microscopy technique developed to observe and image magnetic fields locally. this method is based on application of the hall effect, supplied by a micro hall probe attached to the end of cantilever as a sensor.  shpm provides direct quantitative information on the magnetic state of a material and can also image magnetic induction under a...

The design and characteristics of a micro-system for thermogravimetric analysis (TGA) in which heater, temperature sensor and mass sensor are integrated into a single device are presented. The system consists of a suspended cantilever that incorporates a microfabricated resistor, used as both heater and thermometer. A three-dimensional finite element analysis was used to define the structure pa...

A time-dependent numerical simulation procedure is implemented to simulate the flying height response of a typical thermal flying height control (TFC) slider as a function of the power input to the heater element. The Reynolds equation is used in conjunction with a TFC slider finite element model to determine the change in the thermal protrusion and flying height of the slider. The power input ...

The monolithically integrated all-optical single-sideband (SSB) filter based on photonic Hilbert transform and planar Bragg gratings is proposed and experimentally demonstrated. An SSB suppression of 12 dB at 6 GHz and sideband switching are achieved via thermal tuning. An X-coupler, photonic Hilbert transformer, flat top reflector, and a micro heater are incorporated in a single silicon-on-sil...

Previous chemical heater designs for isothermal nucleic acid amplification have been based on solid-liquid phase transition, but using this approach, developers have identified design challenges en route to developing a low-cost, disposable device. Here, we demonstrate the feasibility of a new heater configuration suitable for isothermal amplification in which one reactant of an exothermic reac...

This paper presents the study of fluid flow and heat transfer in a plain rectangular duct of a solar air heater by using Computational Fluid Dynamics (CFD). The effect of Reynolds number on heat transfer coefficient and friction factor was investigated. A commercial finite volume package ANSYS FLUENT 12.1 is used to analyze and visualize the nature of the flow across the duct of a solar air hea...