Two sodium-bonded, single phase (Uo.8PUo_2)C fueled. Type 316 stainless steel clad fuel elements were irradiated in EBR-II at heating rates of ~30 kW/ft to burnups of 3.7 and 5.0 at ." . No clad failures occurred as a result of the irradiation. Total fission gas release from the fuel was low. Thermal stresses in the fuel resulted in fuel splitting upon initial startup and general fuel fragmenta...

There are several obstacles to the commercialization of PEM fuel cells.  One of the reasons is that the presence of carbon monoxide (CO) in the reformatted fuel, even at a very small scale, decreases the fuel cell performance. The aim of this paper is to investigate the effect of CO in reformatted fuel on PEM fuel cell performance. For this purpose, a steady state, one-dimensional and non-isoth...

proton exchange membrane fuel cells (pemfcs) with a dead-ended anode and cathode can obtain high hydrogen and oxygen utilization by a comparatively simple system. nevertheless, the accumulation of the water in the anode and cathode channels might cause a local fuel starvation degrading the performance and durability of pemfcs. in this study, a brand new design for a polymer electrolyte membrane...

This paper presents experimental test results of a new compressed natural gas direct injection (CNG-DI) engine that has been developed from modification of a multi cylinder gasoline port injection (PI) engine. The major modifications done are (1) the injection system has been modified to gas direct injection using new high pressure gas injectors, (2) compression ratio has been changed from 10 t...

Silicon micro-hole arrays (Si-MHA) were fabricated as a gas diffusion layer (GDL) in a micro fuel cell using the micro-electro-mechanical-systems (MEMS) fabrication technique. The resistance temperature detector (RTD) sensor was integrated with the GDL on a bipolar plate to measure the temperature inside the fuel cell. Experimental results demonstrate that temperature was generally linearly rel...

Large scale power production benefits from the high efficiency of gas-steam combined cycles. In the lower power range, fuel cells are a good candidate to combine with gas turbines. Such systems can achieve efficiencies exceeding 60%. High temperature Solid Oxide Fuel Cells (SOFC) offer good opportunities for this coupling. In this paper, a systematic method to select a design according to user ...

Oxygen transport across the cathode gas diffusion layer (GDL) in polymer electrolyte membrane (PEM) fuel cells was examined by varying the O2/N2 ratio and by varying the area of the GDL extending laterally from the gas flow channel under the bipolar plate (under the land). As the cathode is depleted of oxygen, the current density becomes limited by oxygen transport across the GDL. Oxygen deplet...

Blood carboxyhaemoglobin levels were estimated by double wavelength spectrophotometry in non-smoking women living in Chandigarh and its environs and related to the cooking fuel they used. Twenty nine used kerosene, 28 biomass fuel, and 30 liquified petroleum gas; the 27 control subjects had not done any cooking for seven days. The carboxyhaemoglobin concentrations were significantly higher in t...

A value chain is a series of events that takes a raw material and with each step adds value to it. Global interest in the application of natural gas (NG) in production and transportation has grown dramatically, representing a long-term, low-cost, domestic, and secure alternative to petroleum-based fuels. Many technological solutions are currently considered on the market or in development, whic...