We study atomistically the fracture of single-crystal silicon at atomically sharp notches with opening angles of 0° ~a crack!, 70.53°, 90° and 125.3°. Such notches occur in silicon that has been formed by etching into microelectromechanical structures and tend to be the initiation sites for failure by fracture of these structures. Analogous to the stress intensity factor of traditional linear e...

Fractures, such as joints, faults and veins, strongly influence the transport of fluids through rocks by either enhancing or inhibiting flow. Techniques used for the automatic detection of lineaments from satellite images and aerial photographs, LIDAR technologies and borehole televiewers significantly enhanced data acquisition. The analysis of such data is often performed manually or with diff...

The gas-assisted gravity drainage (GAGD) process is designed and practiced based on gravity drainage idea and uses the advantage of density difference between injected CO2 and reservoir oil. In this work, one of Iran western oilfields was selected as a case study and a sector model was simulated based on its rock and fluid properties. The pressure of CO2 gas injection was close to the MMP of th...

Fluid flow in jointed rock mass with impermeable matrix is often controlled by joint properties, including aperture, orientation, spacing, persistence and etc. On the other hand, since the rock mass is made of heterogeneous and anisotropic natural materials, geometric properties of joints may have dispersed values. One of the most powerful methods for simulation of stochastic nature of geometri...

Most of the existing concrete dams are subjected to cracking. These cracks are caused by various factors such as construction practices, curing, loads and volume change of mass concrete which reduce the efficiency, failure or instability of concrete dams. Using fracture mechanics as a new method to estimate stability and durability of concrete dams is recommended in scientific publications in w...

Natural fractures are important conduits for fluid-flow and can control the deformational behavior of rock. The accurate evaluation of natural fracture geometry in the subsurface is difficult because of the sampling problems inherent to wellbores and indirect investigation methods such as seismic. Because of these limitations in observational capability, predictive models are needed to provide ...

Fracture toughness, critical strain energy release rate, and critical stress intensity factor were determined for experimental and commercial restorative resins. A composite resin had lower resistance to crack initiation than an unfilled acrylic resin. The data were consistent with surface failure observed in single-pass wear studies of these resins.

In this research, an efficient Galerkin Finite Volume Method (GFVM) along with the h–refinement adaptive process and post–processing error estimation analysis is presented for fracture analysis. The adaptive strategy is used to produce more accurate solution with the least computational cost. To investigate the accuracy and efficiency of the developed model, the GFVM is compared with two versio...