Introduction: The aim of this study was to investigate the initial electron beam parameters for Monte Carlo model of 6MV photon beam produced by Siemens Oncor® linear accelerator.   Materials and Methods: In this study, the EGSnrc Monte Carlo user codes BEAMnrc and DOSXYZnrc were used. The beamnrc code were used for modelling of a 6 MV photon beam produced by...

Calcium monofluoride (CaF) is magnetically slowed and trapped using optical pumping. Starting from a collisionally cooled slow beam, CaF with an initial velocity of ∼ 30 m/s is slowed via magnetic forces as it enters a 800 mK deep magnetic trap. Employing two-stage optical pumping, CaF is irreversibly loaded into the trap via two scattered photons. We observe a trap lifetime exceeding 500 ms li...

Optical pumping of atomic vapors can lead to self-focusing of resonant laser beams. The saturation of the optical pumping process at low intensity allows the study of transverse solitons in the form of selftrapped laser beams, using low-power cw lasers. The long lifetime of the optically pumped atoms allows the atomic diffusion to transport the excitation away from the interaction region. Numer...

An electron beam microbunched on the optical wavelength scale of ø2.5 mm by an inverse free electron laser accelerator was observed. The optimum bunching was achieved for a 1% energy modulation of a 32 MeV electron beam with 0.5 GW CO2 laser power. The microbunching process was investigated by measuring the coherent transition radiation produced by the energy modulated electron beam. A quadrati...

We report a systematic study of thermal effects in photonic crystal membrane lasers based on line-defect cavities. Two material platforms, InGaAsP and InP, are investigated experimentally and numerically. Lasers with quantum dot layers embedded in an InP membrane exhibit lasing at room temperature under CW optical pumping, whereas InGaAsP membranes only lase under pulsed conditions. By varying ...

The coordinate and energy distributions of the electron beam density at the Advanced Light Source have been obtained from measurements of the beam lifetime at various storage-ring apertures in the horizontal and vertical planes. It is shown that these distributions have a Gaussian core extended approximately up to five rms beam sizes. Beyond this point the electron density is defined by the ele...

The work presented here is a study of thermally enhanced injection in light-emitting diodes (LEDs). This effect, which we refer to as "thermal pumping", results from Peltier energy exchange from the lattice to charge carriers when current is injected into an LED. For an applied voltage V such that qV < (hw), where q is the electron charge and (hw) is the average emitted photon energy, thermal p...

In KGd(1-x)Lu(x)(WO(4))(2):Yb(3+) channel waveguides grown onto KY(WO(4))(2) substrates by liquid phase epitaxy and microstructured by Ar+ beam etching, we produced 418 mW of continuous-wave output power at 1023 nm with a slope efficiency of 71% and a threshold of 40 mW of launched pump power at 981 nm. The degree of output coupling was 70%. By grating tuning in an extended cavity and pumping a...

We demonstrate a new type of four-pass dye laser amplifier that can reduce the possibility of parasitic oscillation between optical components used in the amplifier. Pumping the amplifier with a 5.6-mJ Q-switched doubled Nd:YAG laser output, we obtain high-peak-power pulsed output of an incident cw narrow-bandwidth dye laser beam with a power gain greater than 2 x 10(6) . Subsequent amplificati...

A gigahertz single-electron (SE) pump with a semiconductor charge island is promising for a future quantum current standard. However, high-accuracy current in the nanoampere regime is still difficult to achieve because the performance of SE pumps tends to degrade significantly at frequencies exceeding 1 GHz. Here, we demonstrate robust SE pumping via a single-trap level in silicon up to 7.4 GHz...