Induction generators are generally simulated by means of a well-known model described by Brereton et al. [1], based on the induction motor equations derived by Stanley [2]. In this model the possibility of opening the rotor circuit in order to inject a voltage source is not taken into account, although there are other models where it is dealt with [3]. This paper presents an alternative way of ...

This paper presents results of a study concerning the dynamic behaviour of a wind energy system powered by a doubly fed induction generator with the rotor connected to the electric network through an AC-AC converter. A tendency to put up more and more wind turbines can be observed all over the world. Also, there is awareness in taking into account the requirements of a clean environment, due to...

Introduction. Nowadays, global investment in renewable energy sources has been growing intensely. In particular, we mention here that wind source of grown recently. Purpose. Comparative study between sliding mode control and vector a brushless doubly fed reluctance generator based on conversion systems. Methods. This paper deals with conceptual analysis comparative two techniques promising low-...

This chapter introduces the operation and control of a Doubly-fed Induction Generator (DFIG) system. The DFIG is currently the system of choice for multi-MW wind turbines. The aerodynamic system must be capable of operating over a wide wind speed range in order to achieve optimum aerodynamic efficiency by tracking the optimum tip-speed ratio. Therefore, the generator’s rotor must be able to ope...

This paper describes the transient behaviour of a doubly-fed induction generator (DFIG) driven by wind turbine after its disconnection from the grid. The induction machine runs at a specific speed with the stator disconnected from the grid (Is=0), the rotor is suddenly excited with slip-frequency voltages derived from voltage regulators so as to produce commended open-circuit stator terminal vo...

In this paper steady state characteristic of a variable speed Doubly fed induction generator (DFIG) is investigated. Torque and speed is used as design parameters for DFIG. From mathematical model it is found that on increase of rotor injection voltage and resistance, the torque speed response is shifted from over synchronous to sub synchronous range. The stability of DFIG operation is entirely...

This paper presents fuzzy logic control of Doubly Fed Induction Generator (DFIG) wind turbine in a sample power system. DFIG consists of a common induction generator with slip ring and a partial scale power electronic converter. Fuzzy logic controller is applied to rotor side converter for active power control and voltage regulation of wind turbine. Wind turbine and its control unit are describ...

This chapter presents the theoretical basics of the electric power generation using doublyfed induction drives in wind turbines. This type of drive is the most utilized in wind power plants nowadays. This is mainly due to its fast dynamic response and reduced power electronics on the rotor side. This latter aspect is responsible for less harmonic pollution in the network and reduced acquisition...

This paper presents a novel current control methodology for grid connected doubly-fed induction generator (DFIG) based wind energy conversion systems. Controller is based on a proportional controller with additional first order low pass filter disturbance observer which estimates the parameter dependent nonlinear feed-forward terms. The results in simulations and experimental test bed obviously...